Jump to content
SAU Community

-

Tommyk
 Share

Recommended Posts

Tommyk Veteran

Tommyk

Posted
Posted

Guys

I have for sale some 17" tyres

245/45/17

2x Bridgestone Potenza RE711's super high performance tyre 70% tread $150

4x Falken Ziex Tyres, 2 have about 40% tread the other two have 70% tread Looking for $200 for the set

Prices are negotiable

Local Pickup in Sydney

Link to comment
https://www.sau.com.au/forums/topic/92753--/
Share on other sites
Tommyk Veteran

Tommyk

Posted
  • Author
Posted

Guys

Need money, so these things have gotta go.

The Bridgestone Tyres only really have about 30%, so I would recommend them pretty much only for drift?

Price lowered to 50 bucks

Falken tyres are located at hornsby

Price drop to $140 for the 4

Link to comment
https://www.sau.com.au/forums/topic/92753--/#findComment-1692996
Share on other sites
  • 2 weeks later...
  • 1 year later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Latest Posts

    • RB25inside
      Compatible rear drive shafts R34 N/A?

      By RB25inside · Posted

      UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • turbo76lx
      Torana Lx Gtr Hatch, Lots Of Pictures

      By turbo76lx · Posted

      Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • turbo76lx
      Torana Lx Gtr Hatch, Lots Of Pictures

      By turbo76lx · Posted

      Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • joshuaho96
      Jacks that fit under GTR lips that can reach the subframe?

      By joshuaho96 · Posted

      Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Kapr
      Boost cut after swap(RB25DET NEO) R34

      By Kapr · Posted

      Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...