Jump to content
SAU Community

Recommended Posts

1997 R33 GTR V-spec Series 3 Rare red colour. Factory Xenon Headlights VERY original condition, only modification is Apexi turbo back exhaust.Quicktrak alarm, tinted windows, Clairion 6 stack CD, 59,000 kms Registered until March 07 CUL8AH $35,000 Phone Jeff 0418-640.495 Located north of Parramatta.

post-15642-1130890818.jpg

post-15642-1130890849.jpg

post-15642-1133820034.jpg

Edited by cul8tr
Link to comment
https://www.sau.com.au/forums/topic/93298-1997-r33-gtr-v-spec-series-3/
Share on other sites

  • 2 months later...
  • 2 weeks later...

Thanks for that, it turns out the colour is known as AR1 - Super Clear Red II. I might just go for that colour when i get mine resprayed :)

Good luck with the sale of your car!

  • 2 weeks later...
  • 1 month later...
  • 3 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 1 month later...
  • 1 month later...
  • 3 months later...

will be in the market for a gtr end of 2007, man i hope i can find a series 3 GTR for 35K, Some lucky basterd is going to grab this :(

Good Luck with sale

  • 2 months later...
  • 4 weeks later...
  • 2 months later...
  • 4 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...