Jump to content
SAU Community

Autogauge Defi-style 3 Gauge Bundle Packs - $175


Recommended Posts

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

wat is the diffrent b/w Mechanical Boost gauges and electronic boost gauges?

Mechanical units require what ever is being measured whether it is boost, or oil or water to go into the gauge. Where as electronic units measure from the engine bay and then send the information back to the gauge.

Mechanical Oil and water gauges are not reccomended for in cabin use. A mechincal boost gauge is fine :)

Link to comment
Share on other sites

  • 1 month later...
  • 4 weeks later...
is the deal still on?

cheers,

Chris

edit - anyone with a 33gtst, could you take a photo and post it up?

Cheers,

Chris

Hi Chris, it certainly is, and we have tonnes of stock :(

Although this isnt a GTS-T, the image below gives you an idea of how the gauges look once hooked up.

On

agsmoked-on.jpg

Off

agsmoked-off.jpg

Cheers,

Steve

Link to comment
Share on other sites

Hi,

I was just wanting to confirm that it is $175 delivered as you advised in the top/middle of this page.

I tried to order package one and when i went to pay for it, it added another $20.

Please verify, cheers,

Hi mate, the gauge bundles are $175 + Delivery.

Regards,

Steve

Link to comment
Share on other sites

You stated above that we can mix and match,.... i am also after "air/fuel, oil and boost"

how do we go about ordering this???

Hi mate, mixing and matching isnt a problem.

If you give Darron a call in store tommorrow on (02) 9545 0532 he can take your order over the phone and organise to get a set out to you asap.

Cheers,

Steve

Link to comment
Share on other sites

  • 3 weeks later...
  • 3 weeks later...
 Share




  • Similar Content

  • Latest Posts

    • Just that it's smaller than the "best" choice out of the available options.
    • Never heard any declare the -9 as a waste of time 
    • BTW, level up linking and @-ing, thanks David I actually don't have much to add, except that I have seen electrical gauges "off the scale" due to some sort of mechanical issue that work properly again after freeing up....sounds like that might be what happened here...
    • Howdy all, A mate of mine picked up an R32 GTS-T recently and it had a very... colourful... gear knob that needed to be replaced immediately 🤣 I put together a replacement which is reminiscent of the Nismo offering, which I also really like both the feeling and design. I basically took what they did and optimising for 3D printing, with the exception of the top chamfer, where I prefer a filleted design, despite it not printing quite as clean. If anybody needs another thread size for the locker or if you prefer a top chamfer similar to the Nismo one, I'm happy to put something together for you and as a side note, I was really impressed by the TPU lock nuts. Originally I was going to use steel and then found out the ones I had on hand were sadly M10 1.5 pitch, rather than the required M10 1.25 pitch, so I had to get a bit creative rather than wait for the bolt shop to open. In the picture it looks a little bit 'rough' at the top due to the layering printing on a curve, but in reality it's not very noticeable at all and honestly feels pretty good in the hand. https://www.printables.com/model/910138-nissan-skyline-r32-gear-knob Regards, Sean
    • Which can be translated into English as "waste of time"/"good"/"too big"/"stupid".
×
×
  • Create New...