Jump to content
SAU Community

Recommended Posts

Hey guys,

As all of you know there is alot of racial tension atm....(unless you live under a rock)

I got these photo's sent to me yesterday.

It apparently happened in Coogee yesterday, round 3ish.

I havnt seen anything about this on the news....coverup?

It must be related to the voilence...

Ive heard things like it was one of the Bra boys cars etc...

Anybody got any details?

post-17623-1134429474.jpg

post-17623-1134429567.jpg

post-17623-1134429605.jpg

Link to comment
https://www.sau.com.au/forums/topic/98276-racial-voilence/
Share on other sites

  • Replies 129
  • Created
  • Last Reply

Top Posters In This Topic

I just got the email and it said "about an hour ago" and the time on it was nearly 8am today.

I got this email at 4.23pm yesterday...so it definately happened yesterday.

It looks like it was either around 8am or 3pm seeing as though there is a school kid on the road....

Link to comment
https://www.sau.com.au/forums/topic/98276-racial-voilence/#findComment-1785444
Share on other sites

Just got this in an email

You have all probably heard about the riots etc in Cronulla, We have

just

been warned as an Insurance Company for Motor Vehicles that the Ethnic

community are ready to retaliate and hit back at the Australian Race in

the

Parramatta Area. Today there were fights and attacks at Merrylands and

Granville.

Just all be careful and don't go anywhere by yourselves in that area.

They

are jumping out in front of cars to see what race you are then they

start

to hit the vehicle, even while you are inside. Do not stop for anybody

and

make sure your doors are locked especially at traffic lights.

All Insurance Companies do not cover acts of Terrorism and Racial Acts

resulting in Riots. So take extra care. They do however cover radom

acts

of violence by an unknown but you have to cover the excess.

Link to comment
https://www.sau.com.au/forums/topic/98276-racial-voilence/#findComment-1786092
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...