Jump to content
SAU Community

Recommended Posts

Does this CAI fit a R34 GT-T? After a clear lid one. I also have a Hybrid FMIC kit, hope this CAI kit doesn't fowl with FMIC piping. Would also like to know where CAI kit is getting its air intake from?

Cheers

still got a few clear lid airbox's :rofl:
  • Replies 116
  • Created
  • Last Reply

Top Posters In This Topic

Do you think it will fit in here without having to move my boost solenoid or alarm siren?

Does the shield go straight down at the back (side towards rear of car)? or does it angle in?

post-24130-1157373545.jpg

Do you think it will fit in here without having to move my boost solenoid or alarm siren?

Does the shield go straight down at the back (side towards rear of car)? or does it angle in?

Hey mate,

The boost solinoid is fine where it is, but the siren is definitly in the way of the back wall. The back wall goes straight down, sorry about that.

Hey mate,

The boost solinoid is fine where it is, but the siren is definitly in the way of the back wall. The back wall goes straight down, sorry about that.

:P DAMN, i tried to make my own, but it turned out pretty rubbish...

I might have to pay to get someone to move the siren, hopefully that can be done

If its not too expensive to move the siren I will buy both the rad. guide and the POD shield from you

Cheers

very keen on one made up for the R32 ;) I'm sure there are heaps of others out there too!

If ever there is one made up please PM me.

No one sells decent heat sheilds for the R32. there is plenty of money to be made. You should even consider selling this products to other shops for distribution!

If you have any still avaliable either clear or solid please let me know.

Can anyone confirm that it fits fine with the Blitz pod filters (the large stainless steel ones) pretty much exactly like "Trooper" .

Thanks Rob

sorry boys i dont have anything to suit the the r34 or r32 and as it stands i dont think i will be able to make one, as i dont have the tiem to redesign a new template.

im not sure if they will fit a non turbo, send me a pic of the engine bay and ill see if its the same as the turbo's.

RedLineGTR: yeap i definitly have clear lid heat sheilds ready for postage if you need one

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...