Jump to content
SAU Community

SOLD

Beer Baron
 Share

Recommended Posts

cattivo_69 Community Regular

cattivo_69

Posted
Posted
that's a good question. I would guess that it will. is your GTS4 an 89 or 90 model? also does it have the torque split gauge as part of the main cluster (like in the above pic)?

yeh has the torque split gauge like pictured above and mines an 89

Link to comment
https://www.sau.com.au/forums/topic/103394-sold/page/2/#findComment-1975901
Share on other sites
  • 3 weeks later...
  • 10 months later...
  • 3 weeks later...
gjc68 Newbie

gjc68

Posted
Posted (edited)
that's a good question. I would guess that it will. is your GTS4 an 89 or 90 model? also does it have the torque split gauge as part of the main cluster (like in the above pic)?

Sorry dude, forgot i already asked you about this. just ignore my emails, unless you have found another one. Have been lookin for a while...

Edited by gjc68
Link to comment
https://www.sau.com.au/forums/topic/103394-sold/page/2/#findComment-2940654
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...