Jump to content
SAU Community

Recommended Posts

No, as far as im aware it activates after 80kmph and only at sometimes? Your hicas light should light up when you turn the car on, only for a second though.

Look underneath your car as previous owner might have removed it and took the light out. It should look like a little motor thing bolted onto the back of your diff.

Dayne

should i be able to see the rear wheels move???

You would not see your rear wheels move as HICAS only make then turn 1 or 2 degrees.

If you really want to test out if it works go into a slide and see if the rear corrents itself...

question...how do i know if my hicas works series 2 skyline.

has the light on the dash i have never seen it ever light up.

is there a way i can see if it works????

there is a diagnostic test that involves stomping on the brake pedal quickly a certain number of times and simultaneously turning the steering wheel left/right quickly a number of times. i'm not joking.

i've seen it done on my GTR when the hicas (highly catastrophic a'hole system) was still installed and the sucker sat there stationary idling, twitching its wheels left, then right until the diag was switched off. there is a thread on here that describes the sequence, do a search and you'll prob fnd it.

to do the test on ya hicas:

a. turn the key to off then with in 10 seconds after leaving the key on 'on' start the car, then turn the steering wheel 20deg from straight going from left to right then pump the brake pedal 5 times and then pause for a 5 seconds or so then press the brake again.

then you should be able to turn the wheel 20deg left or right and the rear wheels should follow suit on a scaled ratio. :P

Interesting that some people think their hicas does nothing up till 80km/h, it's total rubbish. I've got HICAS on my 33 & it works at virtually ALL speeds apart from standstill. I think it doesn't work when the car is stationary as this places too high a load on the steering motor & prevent tyre scrubbing. Though it doesn't move much at very low speeds it does work.

It has a very specific turn angle which it starts to work at which is very noticeable at even 60km/h or less. I've even felt it working when I've done a u-turn with no sliding or throttle & it directed me around the other direction way tighter than I expected & actually induced a little bit of a tail slide.

& yeah the only time the hicas light should show up on the dash is when you first turn the ignition to on. It should go after a couple of seconds just like half the other stuff on there.

Edited by Electro

Wow Jarrod, you know everything!! Better tell Nissan Japan that their detailed info and diagrams that has been presented on this forum numerous times and verified by a multitude of expert drivers is all wrong.

A quick search will get you the info you need Gavin.

yeah i found out a neat way nto check if it works whilst having stalling issues...go on a long streight stretch of road, dosent matter what speed but for safety 20 or 30 ks should be sufficient, put it in nuetral, turn the car off then switch it on to reds, then wiggle ure steering wheel round, and there u go, trolley here we go, then just clutch start it in 3rd or turn ur car back on and continue on your journey.

Wow Jarrod, you know everything!! Better tell Nissan Japan that their detailed info and diagrams that has been presented on this forum numerous times and verified by a multitude of expert drivers is all wrong.

A quick search will get you the info you need Gavin.

Well I'll be interested to read the documentation you're on about once I find it. Because I'm absolutely certain that it functions below 80. I've had a friend observe it working when I'm manuvoring out of his driveway & have parked it with the wheels not straight. It doesn't move a lot at low speed usually unless u slide it (something already noted on here by others) or perform sharp turns, but it's noticeable none the less. Something that would be worth noting is that things rarely stay the same when it comes to stuff like this.

If the info is in reference to a GTR for instance it's always going to be set up differently since its AWD not RWD like a GTS-T (which I have). This wouldn't be overly complicated to do. I'd also suggest that there were several updates to the system over the years as with any bit of technology (mine is a late model 97) , & each one operating differently. There is also I found out electrical & hydraulic versions of the system (mine is electric) though I don't know if that's just on 32's or 33's just yet, but these would also most likely be different in operation too.

I don't confess to be a know all like you are insinuating, but I know mine definantely works at low speeds

Nice Lee. That's the one Funkymonkey translated from the R33 literature. I

t basically does nothing under 80, which is when the power steering firms up. It's the same on R34 as well.....and no mid-life upgrades so I suggest if you can see your rear is moving it's time for bushes as the 1 degree is almost impossible to judge.

Attached is a nissan diagram that shows that hicas only works at mid-high speed proving that it works 80+

Thanks for the diagram, but you seem to be reading a lot into a diagram that has no specific speeds, & this is for a really good reason.

A system like HICAS is NOT going to suddenly start operating differently the moment it hit's 80kph like flicking a switch. Imagine this:

You are mid turning into a corner at about say 70, realise you are going a lot slower than you need to so you accelerate through the corner. When you hit 80 kph mid corner the HICAS decides to suddenly intervene & kick the rear wheels out....... See a problem here? If the system worked like that every second skyline with it fitted would be in a wrecking yard by now.

I'd say more logically that this diagram shows the systems 3 most extreme situations, & that the system would progressively change between them depending on what speed you car is doing. I have it known for a fact that from my own experience the system will do exactly what is shown on the midspeed scenario from as low as 40 kph. I tend to do this most often when turning at right angled intersections & accelerating hard when exiting them. The faster I go the more aggressive it becomes, but it is not suddenly at 80 kph that it starts working.

Sorry guys I'm standing firm on this 1, maybe you should try refitting you HICAS system & test it out for yourselves.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...