Jump to content
SAU Community

Queensland Wasteland


Recommended Posts

  • Replies 28.4k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    4853

  • BelGarion

    4045

  • GTS-t VSPEC

    2546

  • rb25

    2007

Top Posters In This Topic

Guest 87vlt
Originally posted by Squizz

Again you can't see...

If you whore elsewhere it's not my problem.  Simple.

Now go away and become "not my problem", because at the moment you are my problem, and I don't like problems...

you get skyzerr to stop whoring in the wasteland and box to stop in QDL whoreland and yes I will.

Originally posted by Nismo_Boy

i put foward, once we become a paying club, if **** tards like this dont buy member ship they get banned, and **** off.

Thanks for your input Josh, not quite how I would have worded things, but membership by way of payment is not the answer either.

However when signing on to a clubs forum and being asked to adhere to the guidelines set out by the group would be a nice start...

Originally posted by Squizz

Thanks for your input Josh, not quite how I would have worded things, but membership by way of payment is not the answer either.

However when signing on to a clubs forum and being asked to adhere to the guidelines set out by the group would be a nice start...

but people dont read the rules, they scroll down the page and press enter..

Guest 87vlt
Originally posted by Nismo_Boy

but people dont read the rules, they scroll down the page and press enter..

where in this does it say anything about post whoring/spamming?

Skylines Australia Discussion Forums Rules

Registration to this forum is free! We do insist that you abide by the rules and policies detailed below. If you agree to the terms, please press the Agree button at the end of the page. Note: By pressing the button you declare that you are over the age of 13. If you are 13 or under, please use this registration form.

Although the administrators and moderators of Skylines Australia Discussion Forums will attempt to keep all objectionable messages off this forum, it is impossible for us to review all messages. All messages express the views of the author, and neither the owners of Skylines Australia Discussion Forums or Jelsoft Enterprises Limited (developers of vBulletin) will be held responsible for the content of any message.

By clicking the Agree button, you warrant that you will not post any messages that are obscene, vulgar, sexually-orientated, hateful, threatening, or otherwise violative of any laws.

The owners of Skylines Australia Discussion Forums have the right to remove, edit, move or close any thread for any reason.

 

 

and thats what I agreed to.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Messing around with. Twin kit for. Rb30/26  
    • For fuelling the Haltechs have O2WB fuel controllers. Very useful for helping tuning VE and correcting for *small* mistakes. Of course if your injector/cam/trigger/sensor data is just wrong (or for a GTT which is not a GT) then you will get impossible reactions to things. I am sure you know this already but the reason people don't typically put haltechs (or any Aftermarket ECU) on GT's is because there's practically no real gains to be had - So this knowledge won't be commonplace.
    • Can someone tell me if the cracks seen in the rear sway bar bushings in these photo's is unacceptable from a roadworthy point of view?  
    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
×
×
  • Create New...