Jump to content
SAU Community

Queensland Wasteland


Recommended Posts

  • Replies 28.4k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    4853

  • BelGarion

    4045

  • GTS-t VSPEC

    2546

  • rb25

    2007

Top Posters In This Topic

Guest neoGT-25

Japan plans to send their Elite force !

President George W Bush has sought Japan's cooperation in fighting Iraq

after Germany, Belgium & France openly refused to back US. However in

swift respond from Japanese PM, he agreed readily, to send their Elite

soldiers.

President Bush has labeled Saddam Hussein as a vicious MONSTER! that

could create havoc to mankind... however, Japanese PM assured Mr Bush to

put his trust on his Elite Forces which have the experience & capabilities

to fight any kind of so-called MONSTERS... & Iraqis are human after all.

Meanwhile the Japan Defense Ministry has already released the picture of

the Elite Forces after much pressure from the Japanese medias... See

attached picture of the Elite forces which Japan has submitted to UN

Security Council... for approval, of course...

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • If there's enough meat in the housing where you want to put the M12 adapter, then do it, but be aware that if/when you f**k that up you'll probably be repairing it before doing anything else. I'd just drill it out and tap ina 1/4" thread. No need for rocket surgery when the next most obvious thing will do. You could throw a 1/4 x 1/8 bush in there and use the same fitting you intended to use.
    • Is the only issue that the oil catch can is getting filled on hard runs? I'd be thinking more about oil control issues rather then the head lifting, especially as you aren't seeing spiking in the coolant pressure.  Do you need restrictors in the head, or better drains from the head? Does the sump need venting to the catch can?
    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
×
×
  • Create New...