Jump to content
SAU Community

Queensland Wasteland


Recommended Posts

  • Replies 28.4k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    4853

  • BelGarion

    4045

  • GTS-t VSPEC

    2546

  • rb25

    2007

Top Posters In This Topic

thanks Ross - i'll make sure i dont forget it now :(

hehe make ur own pipes .... is that anything like me making a new bracket for my air con compressor that was bought 4 months ago and is still sitting on my bedroom floor haha

nah its cool - he's one of the people that goes around abusing people and you never have to abuse him back because he's doing a good enough job of making himself look like a moron! Plus he works in one of the performance (rice) shops over here ..... u would think he would be a bit more open minded.

Thing is he called me stuck up and he's the one going around putting everyone down ....... anyway im with u guys now :D

Wayne are u a lil pissed by any chance? :(

actually i tell a fib - its suppose to be a joint venture between me an dmy dad.

While i was in QLD my parents had my car .... but my air con stopped worknig and it was 50 degree days over here ..... so they did the nice thing and decided to buy a new air con compressor for me ..... but gen ones are rare .... so they bought a non gen one and it needs a new mounting bracket made up for it. They say its the thought that counts :(

wayne ...... hmmm thats a bit over - only for 3 months or longer? u know if u run from the cops its only going to make things worse hun!

I tailgated a unmarked cop car for about 5km once - that was after i tried to drag it - then proceeded to do 80 in a 60 zone and the same in a 40 zone eventually they pulled me over ...... i admited what i had done wrong when they asked me - they left me go with a warning ..... easy :(

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...