Jump to content
SAU Community

Recommended Posts

well it is a good way to judge the condition of the engine, the lower the comp reading the more worn the engine is, but then again, they could replace the rings and get the comp rating back up before selling...

so take it with a grain of salt, do a check to see what condition the motor at teh time of purchase .. rather than trying to use it as a guide, since there is no way to know that a 30,000 km car hasn't been absolutely thrashed without changing oil, fluids etc. motor could be just as worn as a 80,000 km engine that has been looked after a little.

another way is look at things that wear... like steering wheel, Pedals, the shift boot and hand brake boot. these are all high wear areas. So if the car says 30,000kms, but the rubber on the gas pedal looks like it is showing metal, then you know that the guy is lying.

Ask the guy about tires... how many sets of tires that he has put on the car, and the seats should give a good referance to how much the car has been driven.

In canada we are lucky.... you are not allowed to tamper with the dash AT ALL... if there is a light burned out , and the speedo has to be replaced you need to get a second mechanic to say YES this needs to be done... and EVERYTHING IS DOCUMENTED!

If you are caught tampering with teh dash AT ALL you get some major jail time!

And my suggestion (as discussed at length in a number of other posts) is to completely ignore the km's on the clock as 90%+ of the cars out there have them wound back.

So ignore it and concentrate on everything else, ie rust, seats, steering wheel, pedals, suspension, underneath condition, gearbox feel, is the clutch slipping, are the brake disks ok, etc etc...

Ian

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The spray cans were in the "Kiln" room whilst I was preping the parts,  so probably around 2 hours to get them warmed up, the kiln room has 3 small ovens running at 100°c, 3 medium sized ovens running 100°c, and the large one I used running at 80°c, the room itself was about 28°c, I also spent a bit of time taping up the parts in the room as well, and by the time I was done I would assume that the parts were around that 28°c As for power, I expect a couple of Killerwasps up high would be achievable with the current mods, I'm still running the MZR 2.0 intake and throttle body, and there is a slight mismatch with the 2.0 intake (smaller) and 2.5 intake ports (larger) on the head, this intake is matched and specifically designed to fix this issue with the ports mismatch, the throttle body is also a couple of mm larger, OEM is 65mm, the Bosch is 68mm In the end it will look "prettier" than the molded plastic thing that is the OEM MZR 2.0 intake As for the LSD, it's the OEM Torsen which works fine for what I use the car for, plus, basically no maintenance apart from the occasional oil change
    • I was at Tunehouse in Marrickville (great team over there really know their VR's) , and I spotted this Very clean R35.  
    • Mate , I have the same issue right now with the exhaust noise , if you can tell me what your local guy did , I'll talk to my guys and see if they can do the same. Power is good but it just too loud when put it down. 
    • The other trick I've found with wrinkle black is to put the can in hot water for a bit to warm the paint up, and to pre-heat whatever you're painting. It'll be interesting to see if you pick up any power with the intake, following with interest. Got a proper lsd for this?
×
×
  • Create New...