Jump to content
SAU Community

Recommended Posts

  • Replies 224
  • Created
  • Last Reply

Top Posters In This Topic

would you happen to still have the gauge cluster and ummm there's this black square thing on top of the valve cluster. some wires plug into it. i know im not being specific, but hopefully you know what im talking about.

JETGTS, I'm after the drivers side window winder motor. Do you still have it, and how much do you want to for it?

Also the drivers side button door panel would be good if it's still available. :P

hi you going JETGTS do you have:

* Plastic Dash

* Oxygen Sensor

* Skyline Thing at back says (Skyline)

* Right Side Taillight

Im in melbourne ill come and pick em up in the weekend if you have any

cheers

AK

Streamer - I have just the left shock and I am not separating the turbo and manifold sorry

Peter Behrens - Entire body shell i.e. stripped right down? The chassis front right is lifted 20cm higher than it should be and the firewall is slightly buckled on the right. Everything else is like new

Sciby - the drivers side window motor u r looking at 150, let me know what u think. I'm selling the door interior as one bit sorry.

hehehehe - boost solenoid $20? i don't really know what they're worth - always welcome to come have a look at what i've got though, and i'll try and find the solenoid 4u

naveed - plastic strip the battery is behind? i'm not sure what u mean but I know I haven't sold it! I have it if u can explain a bit better?

WLD747 - I have all of these parts. give me a call whenever and we can discuss

hippy - I have the rear bumper support. Let me know when u want and do u want it sent to SA?

Any questions or if u guys are in a rush just call me 0401 598 511

or direct email [email protected] - cheers Ben

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...