Jump to content
SAU Community

Recommended Posts

  • Replies 57
  • Created
  • Last Reply

Top Posters In This Topic

bump just fitted new set of injectors from powerflowinjection this car is imaculate conditoin there is nothing wrong with this car wont find any in better nick

Link to comment
https://www.sau.com.au/forums/topic/113527-gtr-sold/page/3/#findComment-2208568
Share on other sites

Was the problem with the car stuttering under acceleration fixed? I saw it from a previous thread you made.

na that was old post i think with the 33 gts it ended up being coil packs on that car but this is very tidy it makeing good compressoin, tested at nissan when bought it

Link to comment
https://www.sau.com.au/forums/topic/113527-gtr-sold/page/3/#findComment-2216644
Share on other sites

also forgot to add when had clutch taken out it was the original clutch in there so it suggests that the k's havent been wound back and havent been thrashed if the stock clutch was still in there.also timing belt was checked and was replaced by previous owner,may had 100thousand km sevice but dont know, i still have clutch to prove its the original clutch

Link to comment
https://www.sau.com.au/forums/topic/113527-gtr-sold/page/3/#findComment-2216708
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...