Jump to content
SAU Community

Recommended Posts

ahh ok. Well i'll definatley post the dyno results before and after.. car had 172kw on mercurys dyno (means probably about 150rwkw haha) the only thing thats changed is the FMIC (had a r34 sidemount). Despite a bit of hesitation i'm going back to mercury for the power fc tune, i *hope* they dont stuff me around this time :wave:

What boost are you planning on running?

Why do you wish you went that way?

Cause they are cheap and they work! If I had bought one of them my results would be similar and would have cost me less

if u want a different wing.... can swap for my wing!!!

i'm wantin a gtr wing myself

and hey, since we'll have the same colour cars, wont need to respray or anythin.

hehe

Ha ha good luck with finding somone to bite on that deal :dry:

he's now got shoot out mode.

he didnt before.

shootout mode reads an extra 15 to 20hp more then his dyno tuning software.

Plus it got recallibrated recently, apparently it is more inline with other peoples now

Plus it got recallibrated recently, apparently it is more inline with other peoples now

when i did a tune on a friday and then went for that shootout dyno day at allstar

they were reading exactly same power output.

interesting to see what the outcome is now after the recalibration.

if i got more or less power then before.

What boost are you planning on running?

Cause they are cheap and they work! If I had bought one of them my results would be similar and would have cost me less

Ha ha good luck with finding somone to bite on that deal :wave:

probably 14psi

cool that should take it to about the 230+rwkw range :wave:

You didnt happen to order the biggest one he makes did you?? A guy I know has that one and made 200rwkw a 5psi!

with what other mods?

i'm just gettin over the 200kw mark now and on 18psi

yet got a highflow myself.

cool that should take it to about the 230+rwkw range :wave:

You didnt happen to order the biggest one he makes did you?? A guy I know has that one and made 200rwkw a 5psi!

How much power should his biggest one make Andy?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...