Jump to content
SAU Community

Recommended Posts

u think i wont be poping silly amounts of flames either? remember, no cat + screamers + 4" = flame show ;)

No cat, no mufflers + standard rb20 = flames

I have the footage! It's friggin nuts, good 1 - 2 foot ones as well.

4inch straight pipe, no nothing + t88 = I'll burn ur front bar :D

Hmmm. According to mr hill they will fit. More homework required.

they'll physically fit, however to get them to work u'll need to block off the VCT feed on the block/head, and get the clearances checked

gtr's dont run vct, only rb25's do (not sure bout rb20's)

i was gonna say adjust clearances by using shims, but the rb25 isnt a bucket & shim arrangement like the gtr :D

rb20's dont have vct, they might rb20 just wants to be like rb26s ;)

No cat, no mufflers + standard rb20 = flames

I have the footage! It's friggin nuts, good 1 - 2 foot ones as well.

4inch straight pipe, no nothing + t88 = I'll burn ur front bar :blink:

No cat, screamer pipe, 3" pipe = 2 x flames :D

HOW GOOD DOES "28 WEEKS LATER" LOOK??????

Damn straight I'll be seeing that one. I'm still freaked out from the first one. lol.

no idea, havnt seen any previews :)

post

just coz

hi southerner :P

P.S i felt dirty when i visited ur state last week *shudders*

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
×
×
  • Create New...