Jump to content
SAU Community

Recommended Posts

cant fit the tank in the boot without cutting the boot floor. The tank is 22" tall (3gal) and theres only a max of 20.5" from the base of the wheel well. However the std fuel tank runs right up underneath where the wheel well is, so theres no simple cut and shut way to do it :P

cant fit the tank in the boot without cutting the boot floor

ill be round soon with the 9 inch, i love cutting shit up. You should have seen my mates drop top datto ute after i got to it with a angle grinder.

ill be round soon with the 9 inch, i love cutting shit up. You should have seen my mates drop top datto ute after i got to it with a angle grinder.

haha yeh i love my 9 inch too, gets alot of use at my place lol

the thing is, y need to run a fuel cell to fit the dry sump tank in the boot in a 32. 33 boots are deep enough u can put the tank anywhere

haha yeh i love my 9 inch too, gets alot of use at my place lol

the thing is, y need to run a fuel cell to fit the dry sump tank in the boot in a 32. 33 boots are deep enough u can put the tank anywhere

your gtr is neva gonna be finished

wanna put ur money where ur mouth is?

im sticking to my guns that it'll be ready early december :P

awesome if you get it done in time

but why rush it now its not like you want to cut any corners on the final stages.

Who are you going to be using for tuning??

awesome if you get it done in time

but why rush it now its not like you want to cut any corners on the final stages.

Who are you going to be using for tuning??

heh, im not cutting corners, i've budgeted it out and it's come up as early december being the completion date

that's a tough one. Prolly mark from godzilla, seeing as he tune's his and theo's cars, and im going drag racing, so it seems the logical one. Also i need advice on suspension setup and diff's, and he'd know.

quick around circuits. how many drag car's have they setup?

personally, i didnt like the reception i got when i asked them what they knew about a crank trigger disk setup with the autronic.

my ultimate goal with this car is a 9, but that's not gonna happen for a year or 2 i reckon, main issue being the box

quick around circuits. how many drag car's have they setup?

personally, i didnt like the reception i got when i asked them what they knew about a crank trigger disk setup with the autronic.

my ultimate goal with this car is a 9, but that's not gonna happen for a year or 2 i reckon, main issue being the box

doesnt giant do a low 10 in circut setup, im sure they would know a fairbit about setting a car up to quick at the drags.

yeh they've run a 10.2, but i wouldnt get the support at a test session with cnj as i could with godzilla.

dunno, theres still a few months before it comes time to pick, so we'll see

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...