Jump to content
SAU Community

Recommended Posts

ahaha..ok..

hmm tossing up the idea of buying a a/m FPR or seeing if the standard one works with 740cc.. which sound be flowing 60% at 200 but im going for 240kw. what brand.. had a malpassi before.. not impressed.. perhaps sard..?

perhaps ill try with the standard..any suggestions

The only downfall of the standard reg is flowrate. I think they are limited to 230L/hour or 600rwhp

Why have you picked 740cc injectors? They can easily supply you with enough fuel for 500rwkw. 240rwkw should only require 550cc and even then you won't come anywhere near their max. It's all in the tune. Get youself a Nismo, SARD, HKS or Tomei intank pump (they are all the same pump). They are the best for direct fit and good for up to 550-600rwhp

went for a run round nebo in one fridy nite, farken impressive

P.S shuddup andy :laugh:

the low down pick is unbelievable, comes on boost soo quickly and they rev fast as

they have great torque

Im still buying one as soon as I can sell both my cars

they have great torque

Im still buying one as soon as I can sell both my cars

yeh do it

i dunno if i like the way they ride/handle though. it feels as though they are forward biased, and the center of gravity is too high. spose that can be all fixed with some suspension mods though

yeh do it

i dunno if i like the way they ride/handle though. it feels as though they are forward biased, and the center of gravity is too high. spose that can be all fixed with some suspension mods though

was it an MR??

EG carbon fibre rear wing and not just the blade the Whole thing

The MR has Bilsteins suspension and an aluminium roff to negate that effect you felt

what they say about the GT? Is it motor with the new M3 on the cover?

YEAH TEH ONE WITH TEH M3

that is will be a 5.4 litre v8 with 320kw BUT THE MOST UPSETTING PART WAS HOW UGLY IT LOOKS NOW :laugh:

was it an MR??

EG carbon fibre rear wing and not just the blade the Whole thing

The MR has Bilsteins suspension and an aluminium roff to negate that effect you felt

yep it was an MR

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...