Jump to content
SAU Community

Recommended Posts

groovy.....i am still gettin parts :D

lol trueeeee.

i mite add, if ur going to use an n1 pump, make sure u have the right oil restrictors in, and a drain from the back of the head.

P.S found a sump yet? :ninja:

I will sell you a N1 oil pump, you get it when you buy the rest of my engine :D

for $500 ok no prob...

lol trueeeee.

i mite add, if ur going to use an n1 pump, make sure u have the right oil restrictors in, and a drain from the back of the head.

P.S found a sump yet? :ninja:

why would i need them....seriously.

no i havent...Dan said he had one though and a timing cover etc.

for $500 ok no prob...

why would i need them....seriously.

no i havent...Dan said he had one though and a timing cover etc.

x by 10 and its yours! and that would save you about that much in the long run over building your own :ninja:

for $500 ok no prob...

why would i need them....seriously.

no i havent...Dan said he had one though and a timing cover etc.

lets face it, ur not going to be easy on this motor, and ur going to see it bouncing off the limiter a fair few times. uve read the oil control thread right? rb's spin bearings because of the lack of oil in the sump, that means its up in the head.

restricting the flow to the head, and running an external drain from the back of the head, will help get all that excess oil back down into the sump, where its meant to be.

also, the n1 pumps flow more than the std pumps, but at the same pressure.

lets face it, ur not going to be easy on this motor, and ur going to see it bouncing off the limiter a fair few times. uve read the oil control thread right? rb's spin bearings because of the lack of oil in the sump, that means its up in the head.

restricting the flow to the head, and running an external drain from the back of the head, will help get all that excess oil back down into the sump, where its meant to be.

also, the n1 pumps flow more than the std pumps, but at the same pressure.

Fark that...too much money and i wont be bouncing off no limiter either. i think i will be putting around in this car.

Fark that...too much money and i wont be bouncing off no limiter either. i think i will be putting around in this car.

too much money? wtf are u buying an n1 oil pump then for? :domokun:

for ~50 bucks in mods u could save ur farking engine u toss :D

Fark that...too much money and i wont be bouncing off no limiter either. i think i will be putting around in this car.

whats the point of building it to putt around in it? Thats the main reason i am selling mine! I built it then had to spent the best part of a year babying it and it made me think 'what the hell is the point of this car?'

too much money? wtf are u buying an n1 oil pump then for? :domokun:

for ~50 bucks in mods u could save ur farking engine u toss :D

$50 bucks!!! ok where at...

and where else can i get an oil pump from...Nissan are gonna prob gonna charge me the same amount for a standard one.

whats the point of building it to putt around in it? Thats the main reason i am selling mine! I built it then had to spent the best part of a year babying it and it made me think 'what the hell is the point of this car?'

eh....ok....i mean not thrashing it, but i suppose that didnt help the last one.

$50 bucks!!! ok where at...

and where else can i get an oil pump from...Nissan are gonna prob gonna charge me the same amount for a standard one.

eh....ok....i mean not thrashing it, but i suppose that didnt help the last one.

build it to take punisment or give up now :D

$50 bucks!!! ok where at...

and where else can i get an oil pump from...Nissan are gonna prob gonna charge me the same amount for a standard one.

eh....ok....i mean not thrashing it, but i suppose that didnt help the last one.

all u need is a couple of $5 oil restrictors (chilton can make them up) and the back welsche plug in the head punched out, a pipe fabd up, pressed & screwed into place, a -10 fitting welded onto ur sump, and a piece of aeroquip oil hose and ur done!

i got my head drain pipe from r33_racer, pm him to see if he can make you one

the traders on here can supply n1 pumps for ~$360

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
    • Well the articals keep saying a Q50s (Skyline in Japan) with a new Manual gearbox. I like the talk about the new looks with the round tail lights. I hope they bring back the retro look like they did with the Z
    • Off the back of feedback we have decided to mix up this next Motorkhana at Avalon to have some targeted skills practice for beginners to advanced. Saturday 6th September 2025 8:30am Capped 26 entries Standard Entry Fee: $89 Members Entry Fee: $55 (SAU Victoria Only) Entries Close: Friday 5th February  Where: 55 beach road Avalon. https://maps.app.goo.gl/HNUE3EuNue3sJxh38 Entries: Limited to 26 entrants (Passengers allowed over the age of 14 with a signed disclaimer and same safety gear) Disclaimer: Download  Please electronically sign and email to [email protected] or print and hand in and Driver Sign In. To compete in this event you will require A valid  AASA General Speed licence or (Day license via the AASA Website for $50) MA Licenses are no longer accepted by AASA https://aasa.com.au/  A helmet, long sleeve clothing and a 1KG mounted fire extinguisher recommended (But not Mandatory). Further details within Supp Regs on the enty link. Entry Link > https://www.sauvic.com.au/entry/deca/20250906 You can bring and have a passenger in the car but they need to comply to the same safety and clothing as driver. Bring your car and get to battle others, win, lose or draw. I can guarantee you will have lots of fun. Any questions email [email protected] Entry List: 1.Anna S 2. Luke S 3. Jesse Givens-Lamb 4. Luca Stamatescu 5. Madeleine Stamatescu    
    • Wanna rewrite all of that in, say, 2 or 3 separate sentences, so that we can read it?
×
×
  • Create New...