Jump to content
SAU Community

Recommended Posts

Meet: Chatswood Chase Car Park, Enter off Victoria Ave

Time: 9:00pm, Leave by 9:30pm

Destination: Palm Beach via Newport for Pizza.

Bring: CB's, a full tank of fuel and a good attitude. Do something silly and we arent responsible for it. Please dont do anything silly as we are on public roads. Leave it for the track

Pizza Place:

Lucky's Pep'e Pizza Bar

Shp2/ 303 Barrenjoey Rd Newport 2106 (02) 9979 1756

People attending:

d00dz

N1GTR

rukus

Miss Turbo

LANFOH

smasha

burnsie

Mark R33

A NewTattoo

EVL15H

N1 R33 GTR

E_Lu-SHuN + Others

RedDrifter

evil_weevil

satanic

Liz

Maybes

Mr Ed32

Abo Bob

A31Deviat

benm

silver gts-t

GoldZilla

Links

scathing

Never/Can't make it (damm gaveyard shifts)

Sl!m

Craved

BOOSTD

sproosy

R33-Lovr

Smoky

D_I_F

mr 32

EVERYONE IS INVITED!! Especially newer members

EVERYONE PLEASE BRING YOUR CBs - CHANNEL 25 - Stan will be your radio wh0re

Guys, Chastwood Chase Car Park is underground off Victoria Ave.

See a REAL Map.. Nice try Ando!

post-18389-1149139461.gif

  • Replies 173
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...