Jump to content
SAU Community

Recommended Posts

Hey, I drive a VL (dont flame me, haha), and at the moment, a stock RB25det plus an automatic gearbox from an R33 GTST is being fitted.....

Sorry if this is the wrong forum, and I searched but could find anything, but, I just want to know what this gearbox is like to drive?

Please dont compare it to a manual, I just want to know if its good box for an auto, like does it change gears nicely, etc?

Also, what things normally go wrong with them, what common troubles do they get?

If someone can link me to a review of an automatic R33 GTST, maybe that would be helpful.

thanks

(edit: this should probably be in 'drivetrain and transmission forum, can this thread be moved?)

Edited by b1ancardi

well ive had my auto R33 GTST for 6 months now and its been pretty good, good as in, if you push pedal to floor it lets the engine rev right out to redline,

maybe its the ecu thats controlling that...i dont know, i know alota auto boxes on other cars refuse to let the engine even go near the reline mark.

but the auto box in the skyline is quite happy to do it.

gear changes are very smooth but it can be hard to stick to 70km mark as the turbo tends to want to make you accelerate and if you let go of the pedal you slow down too much.

Edited by R33TOM

ok mate.. remember these words before you read anything else - most on here drive manuals nad have never driven an auto skyline.. thus, they only have a preconceived idea that automatic skylines are shit without having driven one. obviously you know that's not the case, so be wary of what advice you wish to take as some posts will be opinions, while others will be opinions based on the fact that they drive/own an automatic skyline

having said that, i drive an automatic r32, which has a similar (if not the same) gearbox to the r33

troubles i have had in the last 3.5 years? none

how does it shift gears? it can flare on some gear changes but that also depends on the gearbox condition. it drives well for me and changes great 99% of the time

its like anything mechanical - it will last a long and happy life if you service it properly (every 20,000kms) and use it as it were intended

oh, btw, i have a transmission cooler attached to mine, and i believe it was a worthy investment at less than $100 from supercheap

i have read of people running over 200rwkw in rb25 automatics without a hitch :D i personally run 155rwkw through my rb20 auto and it loves it :)

good luck with the conversion,

Warren.

thus, they only have a preconceived idea that automatic skylines are shit without having driven one.

:D its ...ok. I ran it at the track a couple of times foot to the floor and it survived.

It's not so good at cornering fast, as it decides to drop the revs right when you need them...pronounced especially on the rb20.

Ive got an R33 Auto....

Havent had any problems with shifting, slipping etc and i give it a bit of punishment. (Not tooo much tho)

Can anyone else confirm for me.... If i drop the auto into 2 (as it just slides in without pressing the button) to get the revs up would that do much harm to the auto? ...kinda like dropiing down a gear if it was a manual.

I've got the stock auto cooler do you rekon i should upgrade?

Auto Rocks :woot:

A few old threads on the auto:

http://www.skylinesaustralia.com/forums/in...1entry1592531

You gotta filter out the biased and stereotypical replies and just read the worthwhile posts.

http://www.skylinesaustralia.com/forums/in...showtopic=59399

the 2nd thread is a bit off-topic but still helpful, and you may as well do the job properly if ur in the middle of converting now anyway.

:(

Auto Rocks :D

A few old threads on the auto:

http://www.skylinesaustralia.com/forums/in...1entry1592531

You gotta filter out the biased and stereotypical replies and just read the worthwhile posts.

http://www.skylinesaustralia.com/forums/in...showtopic=59399

the 2nd thread is a bit off-topic but still helpful, and you may as well do the job properly if ur in the middle of converting now anyway.

:D

cool, thanks

well ive had my auto R33 GTST for 6 months now and its been pretty good, good as in, if you push pedal to floor it lets the engine rev right out to redline,

maybe its the ecu thats controlling that...i dont know, i know alota auto boxes on other cars refuse to let the engine even go near the reline mark.

It could also be the NVCS (nissan variable cam system), rb25's have vv-t on the intake cam.

The auto box is only a 4speed isn't it?

What rpm do you guys sit at on the freeway eg. 100-110 km/h?

well ive had my auto R33 GTST for 6 months now and its been pretty good, good as in, if you push pedal to floor it lets the engine rev right out to redline,

maybe its the ecu thats controlling that...i dont know, i know alota auto boxes on other cars refuse to let the engine even go near the reline mark.

but the auto box in the skyline is quite happy to do it.

gear changes are very smooth but it can be hard to stick to 70km mark as the turbo tends to want to make you accelerate and if you let go of the pedal you slow down too much.

agreed with all of that. i havnt had any problems with my new gearbox ( i hada replace my old one due to the reverse clutch dying, the drive gears were fine ). and yeah, tis quite easy to redline it and stuff. only problem is how low the revs drop when you take your foot off the pedal, sometimes not good. but apart from that its fine.

isnt it a 4sp with overdrive?

yes.

correct.

? really??

My auto is 1,2,D plus overdrive

ie its 3 gears and overdrive becomes 4th gear

the r33 auto box is very similar to the Patrol auto box.

Im going to mod mine soon with the MV Automatics (Blackwood, SA) valve body upgrade for harder shifts. Already got a big oil cooler kit. Then she'll be sweeeeet.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I hadn't thought about the variable power steering assist. Presumably, it will always be the same level of assist as you get in an S14. The R32/3/4 are either helliishly heavy (at low speeds) if the solenoid is not powered at all, or hellishly too light (at high speed) if it is powered all the time. I presume that it is PWM controlled on those cars. I hadn't thought about the S cars not having variable assist. ugh. What crappy plebby cars they must be!  
    • Hmm yeah that is a good point. It looks like it'll just bolt in with no real issue besides maybe the bushings being different. My other concern was that 2 pin plug that I assume is used in some way to control the rack solenoid depending on the speed signal from the ecu. The DMAX rack doesn't even have that plug though so, don't think it'll matter. Might just order the rack and see how it goes. Will update this when I figure something out
    • I'd say it's a fair bet that the feed and return fluid lines will be in different enough spots that you would need to come up with a way to cut the originals short and adapt with new hard line adaption or braided teflon hoses or somesuch. But really, you have the car, you have the photos of the DMAX rack - you should be able to go out there and see for yourself whether they're in the same or different spots.
    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
×
×
  • Create New...