Jump to content
SAU Community

Recommended Posts

(spell check off)..hehe

Ok, I got my 1991 GTR back from the tuning shop and they said that the #1 turbo is bad (HKSGT2530's) the bearing is going out.

He said that the #2 turbo will suck the air but the #1 turbo blows

it out????? Will a bad bearing cause this?? Also under full accelleration the car runs great but under lets say 1/2 load or 1/4 load (load being pedal position from off to the floor) the car runs really bad, sputtering allot, sounding like a choking chicken..lol!

Please HELP!!!!!!!!!

Link to comment
https://www.sau.com.au/forums/topic/12190-serious-accellaration-problemshelp/
Share on other sites

its not fuel delivery (ie: pump) unless the issue occurs under load.

The plugs can cause this issue if too cold a heat range with too small a plug gap.

Try reset on the ecu?

Does the ecu give any faults in diagnostic mode?

Perhaps the camshaft timing if adjustable gears are fitted, recently happened to a mate of mine.

No codes are registering from the ecu. I just replaced the plugs with NISMO platinum plugs, and no difference.

I think that maybe the exahust cam is positioned wrong???

But, tuning the exahust cam would be very hard due to the #1 turbo being bad right??

My freind is looking for a replacement HKS GT2530 for me and if that falls through then I have to take both off and send them down to HKS tokyo and have them rebuilt!!

Do you guys think that because one of the turbos are bad that could be the reason why it can't be tuned properly right now?

(dumb question but i have to ask)....

Eric

If you have a bad turbo you usually know about it when the thing is full throttle as opposed to losing midrange and low end power.

Is the problem only when boost is present or does it do it when cruising at higher rpms and light throttle?

If it does this on cruise then its not a turbo.

Turbo bearing failure produces noise, if all other avenues are blank then just pop the turbo's off and have a look. Don't just assume its broken.

The turbo problem was diagnosed at the Nissan dealership! They said the the rear turbo is in excellent shape but the front

one is "sticky".

They said that is why the car runs like crap at normal speeds and low load. Under full throttle or full boost the car runs strong but

not as strong as it should. When I turn it off you can hear the rear turbo spinning but the front is not .

(kinda like a frozen caliper on a disk brake-it works badly while you drive but when you slow down it wants to skid the tire..)

I have a couple of freinds looking for factory used turbos so that I can use those temporarally.

We called HKS Japan and they said that only a handfull of shops

are cretified with them to rebuild their BB turbos. And its going to

cost me around 70,000Yen for both. I guess some really special tools are needed??

Here is an updated picture ................

OH and the oil catch tank is temp. disconnected till we get it tuned

properly...lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Went to a drift practice day at a local circuit (held on the reserve parking area behind the grandstand) for the first time in about 15 years. Some kei cars were drifting as well, a not so surprising Suzuki Carry truck, and two 1st gen Daihatsu Copens that were converted to rear wheel drive(!) using Daihatsu Boon X4 transfer case, prop shaft and rear diff, obviously omitting the front driveshafts. They looked really fun to slide. I heard that they cost "about half" as much as a Nissan Silvia etc to run.  On the track 'Tech M' a local BMW tuning garage had a customer track day. Mainly recent models but there was one E36 which looked ancient among all the current models. It was cool watching the drifting and then turning around and seeing random people thrashing their M3/4s  central-circuit-drift-practice-2025-05-18-long-yt.mp4
    • I prefer it with those wheels (sacrilege?) 😋 Here's a photo of a fully original one for reference. The price is $350K....
    • I would like to keep it around 15k but if I need more to make it reliable and not have to worry about the car breaking I can go more. It's my project car so I'm just trying g to figure out what needs to be in it i know basic things like turbo cams injectors I'm just unsure of the size and the specifics so I'm spending alot of time on Google and its mostly rb25 and rb26 not alot on neo
    • This. They would need some tricky maneouvering to keep the income out of the country (the US). Which isn't helpful if that's where you want the income to end up.
×
×
  • Create New...