Jump to content
SAU Community

Recommended Posts

motec are looking for a system admin, sounds pretty good actually.

almost tempting. its on seek for those interested. at their research centre in croydon.

dyno on site among many other super cool tools i would imagine.

there would be some sweet equipment there, im sure their IT stuff would be top notch

Link to comment
https://www.sau.com.au/forums/topic/123855-sysadmin-job-motec/
Share on other sites

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

I had an interview for a position as a Software Engineer there on Wednesday.... we'll see how it goes :D

They gave me a tour of the place too :D

-Patrick

*shakes fist* no no no :dry:

Mine was at 10, when was yours?

damn..... that job would be perfect for me! Pity i still have 6 months left of uni :huh:

Fairly simple setup by the sounds of things. (yeah, $50-60k sounds right)

just do the last few subjects part time if you get the job. work experience is more important than uni experience (yes i went to uni full time, wish i didn't)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks for that mate always a good help
    • It's not really a calibration issue, if the voltage is really at 2V. If the voltage is 2V, then that's what the TPS is putting out, and the Haltech is seeing that and 2V is about 40% open (you know, between 0.45v being closed and something close to 4.5V being fully open). So, that would suggest that the TPS is maladjusted, on crooked, something something something. Or a wire problem.
    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
×
×
  • Create New...