Jump to content
SAU Community

Recommended Posts

Howdy ppls,

Im down for a booking on Tuesday night at Lane Cove River steak house, our steak consumption outlet of choice.

Would tuesday night suit most at around 7:30?

Please confirm as either Carlo or myself will book this on Tuesday morning.

List of steak hurders so far:

Nick

Duncan

Tosh

Tony

Carlo

GSR-13S (Edit: GTR-032) :uh-huh:

Kinks?

Akira

Duncan, Go down Delhi Rd towards chatswood.

As you come down the hill in to the National Park, there will be a bridge going over the river @ a set of lights. The turn off is just before that bridge to the right. The steak house is there right on the river. You can't miss it :P

Originally posted by Duncan

Ahh, one of my favourite tracks through there :P See y'all there

Who doesn't like Dehli road?

Aside from the lone speed camera and slow ass bastards it's the typical single lane country road off Fullers in Chatswood.

Exercise your Skyline!

T.

Originally posted by RONIN

I HATE it when I get stuck behind people who insist on driving 15km's below the speed limit!!! #@%#@!%@#!%^!#$^#^!^$@#  

There's always the 2 lane bit where you can make lots of angry noise going past them :D



  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...