Jump to content
SAU Community

Recommended Posts

HI HOPE SOMEONE CAN HELP ME OUT. SOMETIMES WHEN I START IT UP SEEMS LIKE IT'S ONLY RUNNING ON 5 CYLINDERS. AFTER A WHILE WHEN IT WARMS UP IT SEEMS TO COME GOOD. MAINLY HAPPENS WHEN I FIRST START IT IN THE MORNING. WHAT COULD IT BE?

THANKS

Link to comment
https://www.sau.com.au/forums/topic/131812-32-gtr-running-like-crap/
Share on other sites

1. Your Car Needs a Service.

2. Your Car Needs a Service. + Injector Ultrasound.

3. Your Car Needs a Service. + Injector Ultrasound. + Radaitor Flush & Themosat Replacement.

4. Your Factory or Aftermarket Computer is having Cold Start Up Issues.

5. Something Else.

Edited by AndyMac
I'LL HAVE A LOOK AT THE PLUGS MAY NEED TO CHANGE THEM, YEA IT WILL MISS AT IDLE AND UNDER THROTTLE AS WELL BUT THEN IT WILL JUST RUN SWEET.

AFM......When you start the thing again(cold) tap the AFM a few times.

This will give you the answer straight away...you migh need new ones or fix the old ones.

Cheers

AFM......When you start the thing again(cold) tap the AFM a few times.

This will give you the answer straight away...you migh need new ones or fix the old ones.

Cheers

COOL MATE I'LL GIVE THAT A TRY, THANKS

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...