Jump to content
SAU Community

Recommended Posts

I just got recently pulled over by a cop and he told me that I would need an engineers certificate for my fmic.

Is this correct?

He didn't book me for it but just gave me a warning.

Does anyone know any places where I can get a engineers certificate close to Penrith, Sydney area?

Hoe much do these cost?

Link to comment
https://www.sau.com.au/forums/topic/132102-engineers-certificate/
Share on other sites

if u have a box around ur pod then a fmic should be fine, i had no drama;s gettin pulled over before when the car was like that...

if u plan on doin alot more mods then a guy here in wollongong can do a certificate for $500

ben...

prices start at $500 and go upwards from that. Plus you might need to carry out structural strength/vulnerability testing, collision simulations etc. Then there's the fact that the FMIC can alter emissions, and for that you need an EPA engineers cert... and that's big bucks

EPA tests are free in NSW ( at Penrith RTA) but i don't like your chances of passing a none stock car, especially late model car.

I have been there and done it , a stock R33 GTR just makes it and i mean totally stock.

Actually the cop didn't even know that it was an intercooler.

He said that the car has a radiator already so why do I need that one.

I said that it came with the car.

he didn't like the fmic pipe that goes over the engine.

I also had my stock airbox on although the snorkel was missing because I haven't had the chance to modify it yet

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
    • lights are on just the one click.  
    • Absolutely matters because, while a temperature change will eventually reach a sensor at the end of a static line, the response time is far far far too slow to be useful. Might as well not have a temp gauge at all.
    • When I was eyeing off the 370GT (after deciding I didn't want to spend 30-40k+ to relive my early 20s in an R33) I thought it'd be a good project to add a turbo to it. Now that I have a 370GT, and I've had a couple of chances to open it up, I'm pretty stunned by how much power it makes 🫠 Honestly, the way the VVEL opens it up, it almost feels like there's a little turbo tucked away in there somewhere. It's like Nissan looked at VTEC and said "hold my beer" 😁 Has anyone thrown a turbo into their 370Z or 370GT? Is there a conservative boost level you can run without having to upgrade the fuel system, or are bigger injectors and a bigger pump a given?
×
×
  • Create New...