Jump to content
SAU Community

Car Wont Start


HKS-R33
 Share

Recommended Posts

hey guys, ive been trying to get my car started for the past 2 days and still no go. first i thought it was the battery because it was dead and after i had charged it, it wouldnt take any load. i then changed the battery and still the same prob.

anyone ever had a problem like this before. to me it seems like its electrical because its firing but kinda sounds like something is cutting it off as it starts.

Thanks, Mike.

Link to comment
Share on other sites

failing that, disconnect the AFM and then start it up with half throttle. If that works, you have a dead AFM.

Turn it off afterwards, cause you shouldn't run it for long like that.

Edited by RANDY
Link to comment
Share on other sites

Could be no vacuum in the aac valve, at the back of the plenum near the bulkhead

if it sticks open it can cause a vacuum leak at low revs and cause a stall, or it could stop it from starting at all.

Hey mate, are you saying that my aac valve could be stuffed or something in my plenum?

Link to comment
Share on other sites

Heres a DIY from these forums

Normally this wouldn't cause your car to not start unless there was consistently no vacuum, however I recently had some issues with Idle hunting and occasionally the car firing but not starting, and this seemed to solve my problems.

http://www.skylinesaustralia.com/forums/in...110431&st=0

Edited by Mike_
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • PAR specifically offers stock ratios in their gearset and you could do whatever ratios are physically possible supposedly for no extra cost. I agree 6 ratios is better than 5, the factory 2nd gear is equivalent to the Getrag 2nd gear if you account for the differing final drive ratio though. The Getrag 3rd gear with a 3.916 final drive is equivalent to a 1.6 2nd gear in the FS5R30A. I'm about to swap the transmission out on my car, I'm tempted to send the one I have now out for rebuild with the standard "cross ratio" gearsets out there to see if it really makes such a big difference the next time I pull the transmission.
    • This is what I was looking at next:  https://www.z1motorsports.com/engines/tomei/tomei-rb26-28l-short-block-assemblies-p-45479.html as we can’t bore the cylinders out in hk so better just buy the whole lot in one and install then retune. Everyone saying the weak link are the bolts holding the rods together. I already did valve springs, arp head bolts, hks racing coils, nismo fuel pumps and pressure regulators, injectors etc for the top of the engine. 
    • How do I mount this? Do you have any photos??
    • IMO I would stop there but it's up to you. At the power numbers you're asking about the stock 05U block will start showing issues. Even an N1 block might not be enough. PRP is trying to do blocks and heads that will be ready for big power right out of the gate but it remains to be seen whether any of that is any good. It might be great. It might be awful. It's hard to say until enough people have gotten their hands on one and run it for extended periods.
    • My whp was 418whp and 518hp crank on 98 octane fuel. So decent numbers. 
×
×
  • Create New...