Jump to content
SAU Community

Recommended Posts

I've read a few discussions in the forums on how long people idle their car for (if any) before they drive off, but there's no discussion on WHY it's better to idle for a few minutes or just drive straight off...

Now for the question : I was talking to a thermodynamics professor a while ago and he mentioned that while it is true that oil doesn't fully protect your engine until it is at operating temp, your car is better protected if you drive off straight away and get it up to temp as quick as possible (as long as you don't rev the engine too much); instead of idling for a few minutes to warm it up at the first start in the morning.

Whether you have a turbo or not is irrelevant for this question.

Comments?

Link to comment
https://www.sau.com.au/forums/topic/14177-cold-start-damage-why/
Share on other sites

I cant give you the technical reasons, but I have been told during discussions with a engine builder that once the engine has full oil pressure you should start driving it. Gently of course (off boost).

I would guess this allows for the oil to start flowing properly, heat up more evenly etc.

Basically, before you first start your car from cold (say in the morning) all the oil has drained down into the sump. It's at ambient air temperature, so it's going to be pretty viscous and not likely to flow freely...

You turn the key and start the engine. Since the oil pump only works when the engine is running, and it takes time for the pump to pump cold oil from the sump up into the valve/cam area (and throughout the engine block)

So, you can see that for a certain amount of time the engine is running without any oil!

The exact time it takes for the oil to start flowing freely through the engine depends on many factors - pump efficiency, oil grade, oil temp, climate and the size of the engine. I remember reading that on some older american muslce cars it could take around 2 minutes for the oil to start circulating around the block!!

Since an engine running without oil is BAD, the best thing to do is minimize the wear by not driving off imediately after you've started the engine...Basically you're giving the engine time to become fully lubricated before you put any pressure on it.

Ohh, and turbo motors are even more susceptible to this since the turbo is sitting right on top of the engine - far from the oil pump...

That's how I understand it anyways...:D

After about 15 mins of driving, my oil preasure drops to about 2 Bar, sometimes a little less (on idle that is), while driving it is typically around 4 Bar. I assume this type of behaviour is correct?

I always let mine warm up at least 1 minute, revving it a little (2000rpm - and not continously), so oil can circulate.

yeah i notice that within 10 seconds of turning the key and starting the engine my oil pressure reaches about 4-6bar (depending on how cold it is). After those 10 seconds I'm happy to drive off and after a couple of minutes driving the pressure drops to about 2 bar as the oil heats up. I think most of the damage is done in the first few seconds after startup. Once oil pressure is up then the engine is fully protected.

I let my car idle for whatever time it takes to start it up, reverse out of the garage, shut the side garage door, get a popper out of the fridge in the garage, put the roller door down, get in, put my CD Face in, window down, seatbelt on and get comfortable......

about 2 mins :D

There are many schools of thought on the warm up issue. Some people like to warm their engine up till the temp gauge rises, and then drive off, ensuing their engine is protected.

HOWEVER, you also must remember that the diff and gearbox oil are NOT at optimum operating temp from cold, and even though your engine is warm, doing burnouts etc with cold gearbox / diff is a recipe for a large bang - trust me, i've blown up a number of diffs in my time, a couple backing out and squirting it too hard (not a skyline though).

So, while i think it is important to warm up a bit before driving off (say 2 mins), you should really take it easy for the first 5-10 mins of driving time (under 3000rpm) to make sure diff and gearbox are happy too.

my 2c

Agree with you on that.

In the past I thought I had a problem with my gearbox - difficulty engaging second gear. Turned out that I just wasn't given the gearbox oil enough time to warm up (especially in winter). Not moving, or moving a slow speeds isn't going to warm up the other oils in the car....

okay well from my experience with my old torana race car.... i was young and silly and i had a mate i had to impress so i started it and revved it pretty hard after a little while of idling... about 8k.... went for a spin and wemt to like 8.5k several times and when i put it back in the shed it was fine ... when we went to take it to the drags the next wekend it developed a very bad miss...we changed coild ,plugs,leads,everything......ended up been a broken valve spring......all brand new done like 5 hours on the dyno......was broken from it not been warm enough and the wire in the spring not been ductile(flexible) enough which cause it to break...personally i would rather letting it get to operating temp before driving....reason been that the oil may not be at full protection till operating temp but it has no load on it unlike driving the car......hence idling it will not stress anything till it warms up and you take off..... i alwats warm mine fully before driving.......

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...