Jump to content
SAU Community

Recommended Posts

I took by rear bar off yesterday to fit a tow bar and found a little rust it hasn't done any significant damage yet and I think I should be able to fix and stop it ok.

My car is a 95 R33 GTSt 4 door with 70,000, Never bent and in visualy perfict condition.

I just thought I would let other R33 owners know about the problem so they can check there cars.

To see the problem you will have to pull the rear bar off.

1.

Remove number plate and undo the bolt that holds the bracket down.

2.

There are three nuts on the inside of the boot on both sides behind the trim and below the taillights you will need to remove these from both sides.

3.

With the boot open there are I think 4 maybe more black plastic plug type clips that hold the top of the bumper on they will need to be removed.

They are a bit tricky I tried levering them out with a screw driver but ended up having to use pincers and just pulled them up until they popped out (I only cracked one)

4. Now you should be able to pull the bar off.

The problem area

There is a upside down L shaped bracket (The one the black plastic plug clip things go into).

On my car there is rust stains that have leached down from behind this and a few bits below it where the paint is bubbling up. It looks like moisture has got in between the bracket and the back wall of the boot.

I recommend all R33 owners check this spot, before I pulled the bar off I had no idea my car had any rust. :P:D

Has any one else had this problem?

Are there any other Rust Hot Spots I should know about?

Any Recommendations on how I should go about fixing it ?

Thanks

also big rust spot

is under the spare tyre in the boot

i got a leaky boot so water has collected down there and its starting to rust

can someone help me with this leaky boot business?

its in my other thread

I own both a VL Calais turbo and a Skyline.

What’s wrong with a tow bar on a skyline?

I’m not wanting to tow a horse float just a aluminum motor bike trailer and two bikes a total of 350 kg.

Skylines can tow fine I have seen them towing boats and one with a small pop up caravan. R33 GTS-t 4 doors have a towing capacity of 900 KG

Hi Burns,

After taking the front right hand gaurd off my car, and the right side skirting, there if a gap near where the skirting is screwed onto, at the front. Which has succesfully stored about 3 handfuls of dirt / leaves for the last few months at least.

There were signs of minor surface rust, nothing major, but I am definatly glad I found it now not later :D

I'd reccomend taking the skirting off both sides and giving it a good clean. Especially at the front near the framework.

The VL is for sale

The tow bar on the skyline cant be seen any way it is all hidden behind the bumper except for the tong bit and I will take that off when not using it.

Thanks for the tip glenmcrae I will have a look while the car is all pulled apart.

The tow bar came from Nissan it is a S14 200sx tow bar and cost me $265 with all the bits and pieces.

I was also quoted $395 for a custom one.

I was told the S14 kit from Nissan will fit on the skylines fine and it almost dose the only problem is that there is a bulge in the lower section of the rear boot wall. this bulge stops the tow bar mounts from sliding all the way in to the chassis rails so I will have to have them extended about 3 inches. My car is a 4 door the 2 door might not have this bulge so it will go or piss easy.

  • 11 months later...

about the leak into the boot issue - if your car is parked on a down hill slope, water pools just under the boot lid (where it is supposed to run out, but on a downhill slope cannot go anywhere). The pooling water slowly leaks through a join in the metal. Hope that helps to explain it.

Well thats where mine leaked.

Mike

The tow bar came from Nissan it is a S14 200sx tow bar and cost me $265 with all the bits and pieces.

I was also quoted $395 for a custom one.

I was told the S14 kit from Nissan will fit on the skylines fine and it almost dose the only problem is that there is a bulge in the lower section of the rear boot wall.  this bulge stops the tow bar mounts from sliding all the way in to the chassis rails so I will have to have them extended about 3 inches.  My car is a 4 door the 2 door might not have this bulge so it will go or piss easy.

Burns,

Mate I would be very interested to see if you could take any photos to share of the tow bar on and off. Interested to see what it would like as this is something that could come definately in handy for me, and I am sure some others would be curious to see what it all looks like. Always another option and something to do.

Cheers mate!

-Alex

  • 10 months later...
Tow bars on a stock r33 turbo would be fine. But once u start playing with mods, the way the power come on aint the best for towing as u could easily rip the ass end out of the car when boost hits.

Thats exactly what I was thinking... but on a 4 door N/A R33 it would look sorta ok.

yeap under the spare tyre is the worst area but the problem infact is caused by the tail lights, the sealent on the taillights have worn out and leaks water into the interior of the boot, and hence the water finds its way under spare tyre wat i did to remove the leak was pull out both rear lights, done easily from the inside of the boot, unplug the wires take out the screws and push the lights out, then find a good sealant from an autoshop and reseal it , but make sure that u clean out the junk of the old worn out sealant 1st, its disgusting, but u will find after applying the new seal there wont be nemore leaks :P and u can easily fix the rust

Another R33 rust area is around the drivers side window wiper shaft, just as it comes out of the cowling under the black plastic escutcheon There is an indentation around it with no way for water to drain. I had to drill out one of the bolts that secure the shaft to the cowling as it was rusted and seized. A small hole drilled in the depression will fix it....

  • 1 month later...

Best rust treatment i know of is cold galv, but kill rust does the same job with a gloss finish, dont know if it comes in a spray though. I usually clean off rust spray cold galv then with a matching gloss

Another spot for rust is the engine bay chassis rails there is a folded sheet that runs along the top and rust gets between seen this on a import that was rejected because of it. They cut out the chassis no. and took all the id plates.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Cheers. Skyline is back on the menu, can’t get rid of it. It’s like a child you don’t want, or herpes 
    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
×
×
  • Create New...