Jump to content
SAU Community

Stock R33 Turbo, Rear Hausing Need One Asap


Recommended Posts

There is a lot of ORs there. But basically my car is experiancing boost creep, as the stock wastgate is too small with all the mods. So i need to have a look at a stock hausing to see how much i can machine out.

Can comone post a pic up of the gate, closed and opened, so i can get an idea how much you can take off.

Alternativaly. if somone has a stock rear hausing, can i buy it or lease it, so that i can machine the hausing and then swap mine over etc.

Also, if anyone has an R32 10psi actuator, can you give me a bell.

As is the car boosts to 10.6psi with the gate fully wired open. The problem is the wastgat starts to open at 7psi and the GIZZMO IBC can not compensate for that much creep.

ALSO how else can i cure boost creep? At the moment, the wastgate pressure tap is taken form the IC pipe, before the TB, like the stock one, if i tap it off the turbo hausing, will that help at all.

Edited by WogsRus

G'day, I have an R32 turbo I split in half and ported the w/gate hole but needs bigger flap made and fitted. I have a piece of stainless to turn one up. Without replacing flat you would be lucky to port 2-3 in diameter out of w/gate outlet hole (going by R32 turbo).

so how much can i port keeping the standard flap, 2-3mm or something like that??? I only need to reduce the creep by 3 psi, but if you can only take out so little, i might just leave it and run with 10.6 psi LOW setting.

i have an r34 turbo lying around somewhere absent the exh wheel, ill dig it out for you as i only wanted the compressor housing :miner:

edit: just putting the r34 housing on "might" cure your problem because i would expect that nissan would have corrected that with the neo turbo?. just a thought

Edited by toffy
HAY toffy, you got that R34 housing somwhere???

yeah mate, ill dig it out for you, its upto you if you wanna buy it or not, i say try it on and if it doesnt fix the problem then port yours and give mine back?, hows that sound? >_<

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...