Jump to content
SAU Community

Wtd: R32 (non Gtr) To Swap For Vl Turbo And Cash.


Recommended Posts

I want to upgrade to a Skyline but that will require selling my VL turbo first. Just trying to kill two birds with one stone (don't like my chances).

It's a white over silver berlina converted to a calais front.

Big front mount intercooler.

High flow turbo.

Dual stage boost controller.

3' turbo back exhaust.

Keas stage III four spd auto with a 3200 stall.

Trans oil cooler.

Rebuilt LSD, 3.45's.

Bocsh 910 fuel pump.

3/8 fuel lines.

Malpassi fuel reg.

Air conditioning.

Power steering.

17' RJR Blade mags.

LE rear wing.

Lowered springs and slotted rotors.

email me for pics. [email protected]

Edited by RB30X

Might help if you pop up a ball park figure as to what your wanting for the VL...

Ie. You willing to swap your VL plus $xxxx cash for a clean standard R32 GTS-T...

240 000kms and 10 000 since the engine rebuild.

I'm hoping my VL would be worth between 8 -10 grand so take that off what you'd think you Skyline would be and that would be the cash amount.

Edited by RB30X


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...