Jump to content
SAU Community

Recommended Posts

just saw a pic of kenny's bmw at wsid from a meeting just prior to xmas on cackling pipes

howd it go champion?

Shane, fourth time outto WSID in this trim and fourth problem. The car developed a misfire on the first pass so back on the truck and back to the workshop :-(

do i recall you saying you had bolt in intrusion mate, what ws the comment from tech inspector, i tried to make a rule submission to allow sub 10 but higher than 9.00 cars aloud to run bolt in with 6 point as they do in NHRA, but i was told insurance company is what will not allow it so no point putting the $25 in to try. apparantly it has been asked many times in the last 2 years.

im going to have to go full 6 point in the next couple of months with the new package, not liking the idea of no street driving.

do i recall you saying you had bolt in intrusion mate, what ws the comment from tech inspector, i tried to make a rule submission to allow sub 10 but higher than 9.00 cars aloud to run bolt in with 6 point as they do in NHRA, but i was told insurance company is what will not allow it so no point putting the $25 in to try. apparantly it has been asked many times in the last 2 years.

im going to have to go full 6 point in the next couple of months with the new package, not liking the idea of no street driving.

Yes I do have a removable bolt in intrusion bar in the driver's side, however the rest of the six point cage is fully welded in. It is ANDRA tech inspection legal when you follow the rules with regards to sizing, etc.

You can get a six point cage engineered for street use.

  • 2 weeks later...
Yes I do have a removable bolt in intrusion bar in the driver's side, however the rest of the six point cage is fully welded in. It is ANDRA tech inspection legal when you follow the rules with regards to sizing, etc.

You can get a six point cage engineered for street use.

But you cannot get a six point welded in cage engineered for street use.

Best of luck with the BMW's drag racing.

But you cannot get a six point welded in cage engineered for street use.

Best of luck with the BMW's drag racing.

mmm

i was reaidng a release formt eh RTA last week and it said 6 point was a no no and couldnt be engineered, the way i read it though if it was engineered before a certain time, then you are fine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...