32GTR Rear Seat Removal

[mtam22]

Sorry, this must be really irritating. I recall seeing a recent thread on this but can't locate it. So here's the question again, how do you remove the damn thing? I need to get some signal lines and 0-guage wire to the amplifiers at the back. I've slipped my hands under the seat but the metal plate at the back seems inpenetratable.

Many many thanks in advance.

Michael

[mtam22]

I was just told to yank the bottom part out by pulling from the middle but nothing came out except for little pieces of sponges... Help:headbang:

[dAVE]

i done this on a r33 and soarer.. both pretty similar..

undo 2 bolts facing u - one on either side....

then lift right up ... so not towards u.. but up.. sometimes if it hasnt been done before it needs a solid yank... u could also use a big screw driver for leverage.

[vspecv]

clip either side of rear seat a decent yank from both sides will free the seat.

put ur hand between seat and carpet and lift up,you have to do from both sides.

basically get in the car put ur ass against the back of the frt seats bend over and yank the seat up.

[mtam22]

I slipped my hands under the seat and yanked with all my might. I am 100% sure that even if I pulled until the chassis twist, the damn seat will still not be coming out. Now I'm getting my hydraulic jack.... Can someone please explain how exactly is the lower seat held down to the chassis? I can feel that it's got two struts going down each side of the front edge but I can't see what actually is holding them in. Are these clips?

I assume once the lower seat is out, it should be easy to undo the two bolts holding the upright and it'll just slide up and out?

Many thanks

Michael

[NIZR34GTT]

Try The OXY if all else fails

.

[dru32]

i also want to take the rear seats out, Ive got an r32 gts4, ive tried pulling from all directions... Seems like there is something in the middle of the seat holding it down :confused:

[AtomicBomberMan]

just grab and YANK and YANK and YANK! they're held in really well by these plastic clips. i actually managed to get one side off but the other side refused to budge! i ended up putting a piece of wood under the seat, put a long screwdriver thru the locking loop clip, rested the driver tip on the wood, and levered it out! didnt come out without blood sweat and tears, oh....severe cramping though.