Jump to content
SAU Community

Recommended Posts

hey guys,

i realise that there are topics on this but theyre all not quite exact.

what im asking is, my 95 R33 series one n/a, when i fill it up, i usually only get say about 350 kms, i dont really thrash the motor, just normal driving, and the motor is completely stock.

is this normal or sumthings up?

any suggestions on increasing my fuel eco? and how much so i can budget $$$.

Thanks. :)

by the way, how many litres my skyline? ive always wondered.

Link to comment
https://www.sau.com.au/forums/topic/151939-proper-fuel-cinsumption-or/
Share on other sites

The r33 fuel gauge is notorious for being inaccurate. you should do the fill up and mileage calculation to determine your actual fuel consumption / 100km. then work from there.

if you havent done a major service for a long time. it would pay to do so.

I'm guessing RB25's (your engine) have oxygen sensors in exhaust the same as older RB's

My car is using a lot of fuel at the moment due to a choked up catalytic convertor, which has caused the

O2 sensor to play up..... they can just wear out anyway. Apparently common for them to go in hotter weather.

If the ECU is not getting accurate readings..... it will over fuel so as not to run too lean and damage engine.

Check/get checked your O2 sensor..... take it to a mechanic and get them to do tune and check for stuffed sensors..... could just need a good tune up.

def the 02 sensor.

just pull it off. and hold the washer on the end.... than shake it with your hand.... if you can feel and here the a lil thing inside it rattling around... its stuffed.

so get a new one. will make the biggest diff ever dude. prob make your car go better to.

cost.... Around 80-100bucks

Wow 350 to a full tank... i get around 400 and thats with mods too... this is only when my foot feels like a feather for a week changing gears at 3-4k... Do alot of people get around 400 or is it usually 300-350?

haven't had a look, but how hard is it to get the o2 sensor out?

you just un clip it from the main wire that runs to the ECU. the i think its a 12mm spanner. to un screw it. its located on the zorst manifold. easy to find. it has 3 wires coming out the back of it.

"get about 430..on a 93 r33 GTST..

im wondering though, do the r33s have an empty light cos ive never gone that low before"

Yes R33s have an empty light. But im told that it comes on once the needle gets BELOW the empty line. Im pretty sure that R33s have a 22L reserve, so when you look at your fuel gauge and it says empty, youve only used 2/3 of a tank. Well thats the case with mine anyway

I remember with the 32's when you hit the empty light you have left ~10litres.

The old Rb20DET running 1bar used to average470km's per tank and that was giving it a bit also.

The RB30DET has dropped a touch to ~450km's per tank giving it a bit also.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...