Jump to content
SAU Community

Recommended Posts

  • Replies 74
  • Created
  • Last Reply

Top Posters In This Topic

well bkc.

here are a few tips for you.

cams will generally reduce your idle quality (lumpy idle, and you will most likely have to raise it to 1000 or even 1100 rpm to get it stable)

cams will generally reduce your fuel economy

cams will generally increase your emissions

now, please note I said 'generally' not always. mild cams will not have a marked effect.

by far the most popular choice in aus at the moment for RB26 running between 400 and 600hp would be Tomei Poncams Type B (260/260, 9.15/9.15).

If you are running around 600hp they would be a good, safe choice.

well bkc.

here are a few tips for you.

cams will generally reduce your idle quality (lumpy idle, and you will most likely have to raise it to 1000 or even 1100 rpm to get it stable)

cams will generally reduce your fuel economy

cams will generally increase your emissions

now, please note I said 'generally' not always. mild cams will not have a marked effect.

by far the most popular choice in aus at the moment for RB26 running between 400 and 600hp would be Tomei Poncams Type B (260/260, 9.15/9.15).

If you are running around 600hp they would be a good, safe choice.

1- stock fuel pump & injectours for 600 hp to the wheel ??

this same duration & lift cam for the power inlet ,exhaust are you mean that ?.

but : and if I want the response Difference is better ?

I mean if fit it up grade the cam shaft for the GTR34 ,

what is the better same ( duration & lift)) for the power or

difference(duration & lift )) ?

The same question if I want response ?

what is your opinions ?

note: I don't mean mark !!

I mean if fit it up grade the cam shaft for the GTR34 ,

what is the better same ( duration & lift)) for the power or

difference(duration & lift )) ?

The same question if I want response ?

what is your opinions ?

note: I don't mean mark !!

Where are the brave young men where they went? :):P:)

post-37443-1177359679.jpg

I mean if fit it up grade the cam shaft for the GTR34 ,

what is the better same ( duration & lift)) for the power or

difference(duration & lift )) ?

The same question if I want response ?

what is your opinions ?

note: I don't mean mark !! :sick:>_<

i think something similar as to what im about to say was said earlier by 'Beer Baron'

Tomei list their higher end Poncam (type B) with the same duration for both the inlet (260) and exhaust (260) cams

Whereas, their base level Poncam (type A) with different duration for the inlet (260) and exhaust (256) which supposedly gives more mid range punch, thus providing more response.

The better one is what YOU want. I think since youre chasing that magical 650 rwhp mark, then youll need to rev and make peak power. HKS list there stage 2 cams as 272 degrees duration for both the inlet and exhaust with some 10.2mm of lift. I think you need to focus less on the differences in duration and more on whether you want 'stage 1' or 'stage 2' cams and then pick one.

thanks

i think something similar as to what im about to say was said earlier by 'Beer Baron'

Tomei list their higher end Poncam (type B) with the same duration for both the inlet (260) and exhaust (260) cams

Whereas, their base level Poncam (type A) with different duration for the inlet (260) and exhaust (256) which supposedly gives more mid range punch, thus providing more response.

The better one is what YOU want. I think since youre chasing that magical 650 rwhp mark, then youll need to rev and make peak power. HKS list there stage 2 cams as 272 degrees duration for both the inlet and exhaust with some 10.2mm of lift. I think you need to focus less on the differences in duration and more on whether you want 'stage 1' or 'stage 2' cams and then pick one.

thanks

Tank you for your reply

I can get 600hp to the wheel,, change up grade fuel pump intank ? & 650cc injectours ,,fuel reglator,, cam

shaft Tomei 260,,915,,X 2 i need know metal heade gaskit & turbos ?

what is opinion ?

post-37443-1177393296.jpg

If you want the mines R34 gtr it has HKS 2530 turbos.

You don't need a new fuel pump. The stock one is fine. But if you have to spend money so you can have a nice long list of aftermarket parts to show to your woman or sheep or whatever then go the Tomei in tank pump.

You don't even need after market cams. Some of the fastest low mount cars down here are running on stock cams with either garret 2860-5's or 2530 turbos and are all making around your 600-650HP. Some of the cars that have put cams in are now going back to stock cams. I had the Tomei 260-9.15's and have just changed back to stock cams on my R34 GTR.

If you want the mines R34 gtr it has HKS 2530 turbos.

You don't need a new fuel pump. The stock one is fine. But if you have to spend money so you can have a nice long list of aftermarket parts to show to your woman or sheep or whatever then go the Tomei in tank pump.

You don't even need after market cams. Some of the fastest low mount cars down here are running on stock cams with either garret 2860-5's or 2530 turbos and are all making around your 600-650HP. Some of the cars that have put cams in are now going back to stock cams. I had the Tomei 260-9.15's and have just changed back to stock cams on my R34 GTR.

Thank you very much man :mad:

are you sure do you say ?

but I don't know garret 2860-5's turbos you can give me site ?

600 hp to the wheel ?

thank you thank you thank you :(

MINE's crazy response !!:rofl: & good power !

note: MIN's stock metal head gaskit & how many full boost ?

post-37443-1177395881.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...