Jump to content
SAU Community

Recommended Posts

Guys,

I'm selling my Autronic SM4 ECU (Autronics best ECU) and direct fire CDI unit.

I've had them for less than 6 months and the car basically hasn't driven in that time. I need to sell them to pay for some bills. :P

Information on the units can be found at:

Autronic SM4 - SOLD ($1800)

Direct Fire CDI - http://www.autronic.com/page_files/direct_fire_cdi.htm

I also have an RB26 trigger disc to suit.

Price: $800 for CDI only

PM or contact me on 0419 375 140.

Link to comment
https://www.sau.com.au/forums/topic/167388-autronic-sm4-and-cdi/
Share on other sites

Loom setup for skyline I'd assume?

Any other sensors with the Autronic?

Cheers.

Pretty much there isn't going to be a loom. Well there is going to be about 1ft of loom as the autronic was spliced into the standard loom in my car rather than had a seperate loom run.

Pretty much there isn't going to be a loom. Well there is going to be about 1ft of loom as the autronic was spliced into the standard loom in my car rather than had a seperate loom run.

Well that sucks nuts. I'd need a full flying lead for custom installation. Don't guess you know the going rate of a replacement flying lead loom? I couldn't find anything doing a google.

Ah well, was considering an SM4 from the get go but couldn't find one, so I purchased a Haltech E11V2. Don't think I'll bother switching if its going to cause me a heap of grief.

Cheers,

James.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...