Jump to content
SAU Community

R33 Skyline Sold!

tuitahi
 Share

Recommended Posts

tuitahi Community Regular

tuitahi

Posted
  • Author
Posted

^^Thanks Billy!!^^

I added some pics I took on my phone.

Over all the car is very straight, it only has one tiny dint on the driver's door.

I had one incident in the car ~4 months ago which resulted in panel damage down the passenger side after a stupid lady side swiped me. There was absolutely no stuctural damage and the car was repaired at Lansvale smash with all new panels (guard, door, sil, skirt, rear quarter) from Nissan Japan along with a full strip and respray of the bonnet. It was an awesome job and insurance forked out close to $8k! and the car is looking better than ever.

tuitahi Community Regular

tuitahi

Posted
  • Author
Posted
Hi tuitahi how are you?

If you dont mind could please up load dyno sheet pic?

Someone asked me how much my chip will make the car faster.

Hey Toshi, I'm good thanks!

I couldn't find the dyno sheet so I grabbed a screen capture from the SAU dyno comparison;

dynograph.jpg

weeman1 Collaborator

weeman1

Posted
Posted

hey everyone, im the fella that bought drew's car

its a great car im so happy with it, im starting to get the clutch under control lol.

thanx again mate all the best to ya

mitch

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • GTSBoy
      Cas issue

      By GTSBoy · Posted

      The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Duncan
      RB26DETT Sketchy boost mod?

      By Duncan · Posted

      Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • nash47
      Cas issue

      By nash47 · Posted

      Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...