Jump to content
SAU Community

Recommended Posts

Got mine.

Thx heaps

just 2 questions.

Where does it say ADR approved?

And it says on the bottom that mine is for R33 gtst but i have r34 gtt.

That wouldn't matter would it?

  • Replies 97
  • Created
  • Last Reply

Top Posters In This Topic

Yeah everyone should have them today I think. Ask at PO tomoz if you haven't got it by tomoz arvo.

Fuji, I haven't actually seen them in person yet sorry. I'm sure they would have sent you the right one. Heaps of stuff is interchangeable between 33 and 34.

Hi

is the R33Gtr lines the same as the Nissan Stagea 260rs? Its got the samebrembo callipers and rotors as the R33GTr. Are they available for my rig? ANd are the clutch lines still available?

If not are you going to organize a second GB in the futre? THanks

Yeah everyone should have them today I think. Ask at PO tomoz if you haven't got it by tomoz arvo.

Fuji, I haven't actually seen them in person yet sorry. I'm sure they would have sent you the right one. Heaps of stuff is interchangeable between 33 and 34.

Got mine.

Cheers...

KJ

  • 2 weeks later...
  • 1 month later...

Hey Adam,

I missed this.....any chance I can still get it done?? :D

(I know you said its closed but worth a try!!! :( )

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...