Jump to content
SAU Community

Recommended Posts

Hi guys,

I am wanting to know what is required to change if you upgrade the stock turbos to a direct bolt-on, such as the Garrett 2860r -7's?

I know you can get the genuine gaskets from Nissan, wondering what exactly i need, and where is the best place to source them from?

Anyone have any contacts??

Cheers!

Dan :D

Link to comment
https://www.sau.com.au/forums/topic/176213-r32-gtr-turbo-gaskets/
Share on other sites

and manifold to head gaskets, also turbo inlet gasket and turbo outlet gasket, also washers for the oil feeds and water feeds and for the oil drains and water drains. there is a nissan gasket kit that has all that stuff in it.

there is a nissan gasket kit that has all that stuff in it.

hey BeerBaron do you mean the 'engine' gasket kit available through nissan-which has head gasket etc. as well? or have you found a supplier who does a 'turbo changeover' set, with only the required bits and pieces? my local nissan dealership spares guys say it has to be ordered seperately :)

hi mate. there is a nissan turbo gasket kit. I am not 100% sure which gaskets it includes but the nissan part number is 14401-24U26. It should cost around $150 or so. at worst it you may have to buy the manifold-head gasket seperately.

failing that HKS sell a kit too with all the gaskets but it's around $300 or more.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
    • So 10/10 times that code is coil packs? I mean if that's the case ill drop the $400USD or so to replace them. I didn't know these cars threw codes before the issue became an issue.
×
×
  • Create New...