Jump to content
SAU Community

Recommended Posts

Hey Guys,

I have an R33 S2 and I am currently trying to decide on what to do with the spoiler. I have a Drift/Stealth wing sitting in my garage and was going to fit that, but recently thought about removing the stock spoiler and just bogging the holes up. I never used to like the look of it, but now i think it looks quite good.

What do you think looks bette

Also, when i decide on one or the other, where in Adelaide do you recommend i get it done? (properly).

post-28991-1186192818_thumb.jpg

Thanks,

Cas.

Link to comment
https://www.sau.com.au/forums/topic/179353-stealth-wing-or-no-wing/
Share on other sites

Stealth wing is much better than no wing, but even the stealth wings are getting too common, i also have one.

Keep the S2 wing and fit a genuine Nissan R33 boot lip, under it. My mate fitted mine to his car with a S2 wing, it looked PHAT! Unfortunately i have no pictures of his car, with the wing, as it was only done recently.

Here is an OLD pic of my car with the boot lip:

post-1811-1186211987_thumb.jpg

u need a spoiler of some sort on a 33 cause of the way the rear gaurds/boot is designed. looks shit without.

The only one i like on a 33 is the one that Darren (Deluxe) has, i'm sure he'll post a pic for ya when he see's this thread!

u need a spoiler of some sort on a 33 cause of the way the rear gaurds/boot is designed. looks shit without.

The only one i like on a 33 is the one that Darren (Deluxe) has, i'm sure he'll post a pic for ya when he see's this thread!

can you post a pic?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...