Jump to content
SAU Community

Recommended Posts

hey guys,

i have had my gtr sitting for about a year and went to start her yesterday and she doesnt want to kick over??

anyways i checked everything out and 4 out of 6 of the coil packs were sitting in water (down where the plug is), looks like it has been sitting there a while too. so i got all the cr@p out and fixed that up.

also, the fuel has turned to varnish.. i took the filter out on the pump side to find out if i have any pressure. i turned the key and some fuel came out but not that much and then after about 4 seconds it started dripping like it was clogged? i turned it off and then back on and there was nothing still? waited 30seconds and redid it and pressure and then it died again!

im wondering if the pump is dead, causing it not to crank over? or could it be the spark plugs.. new iridums.

dan

Edited by Rude Carz
Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/
Share on other sites

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

ok, i just cleaned the lines that go prety much up to the reg..

i have checked the packs for spark.. all clear..

i have checked the packs with plugs on the end.. all clear..

so, its got fresh 98octane in it.. clean lines, tank, and pump.

what the hell else is there?

help!

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3280815
Share on other sites

ok, injectors were fully flow tested and cleaned today, they were fully blocked..

still.. she is not cranking over, put some aerostart in the vac lines and she wanted to start but couldnt..

i am begining to think its the CAS. it might be stuffed or seomthing??? i dont believe i am getting any power to the injectors.

either that or the ECU is stuffed!

i need some advice here!!!!!!!!!

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3285105
Share on other sites

ok, injectors were fully flow tested and cleaned today, they were fully blocked..

still.. she is not cranking over, put some aerostart in the vac lines and she wanted to start but couldnt..

i am begining to think its the CAS. it might be stuffed or seomthing??? i dont believe i am getting any power to the injectors.

either that or the ECU is stuffed!

i need some advice here!!!!!!!!!

It may have fouled plugs, pull one out and see if there wet with fuel.

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3285188
Share on other sites

so i take it you're sure the injectors are firing properly now? maybe pull them out and take the cas off and give it a spin too verify that they are properly working..

after having the coil packs sitting in water for so long perhaps the springs that sit inbetween the bottom of the coil pack and the spark plug have become corroded, try checking them out :D

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3285262
Share on other sites

U need to remove an injector plug from the top of one of the injectors and insert a noid light in the plug.

If u are getting a signal from the ecu the light will flash,meaning if u have spark like u say its not likely

the ecu. Next step would be to check compression.

U may be able to purchase a noid light from repco etc or borrow one from your mechanic.

Good luck

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3285319
Share on other sites

  • 2 weeks later...

ok, just ran ecu diagnostic and got a 55 back.. so all is good there.. i dont understand???

i shot some aerostart in the vac line and it wants to crank over and splutters a bit and waht not..

i have pulled out the CAS and it is fine although i havent put the ign on a turned the sensor to see if there is injector pulse..

HELP

does anyone live in brisbane and would be able to help me out?? PLEASE!

dan

Edited by Rude Carz
Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3308825
Share on other sites

Mate trhis may sound silly but have you changed the fuel filter since you said it was blocked? If you really wana know, pull out your injectors, crank the car & see if they spray fuel. Maybe even one will do... Do the same with your plugs if you havent already

Link to comment
https://www.sau.com.au/forums/topic/180298-gtr-wont-start/#findComment-3309111
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
    • To re-cap, I bought: https://www.alibaba.com/product-detail/Lsailt-8G-Infiniti-Q50-Q60-2014_1601171829627.html?spm=a2756.trade-list-buyer.0.0.2cd476e9FTIlKE As you can see, if I bought 20 it was $653, but I bought 1 so it was $1,170. I was very tempted to buy 2 and resell 1 at 25% cheaper. @MBS206, I am not sure if they do a Kluger one, here is their list but it might be there under a global model name: http://www.lsailt.com/product/android-interface?page=1 Keep in mind these full android replacements have basically all the bits a phone does (cpu, ram, storage, wifi, bluetooth, usb interfaces) other than a screen (it uses a host), thus the $800+ cost. Android Auto screen mirroring is MUCH cheaper as it's just a cut down shell, input mirroring and output mirroring BTW I also need that "screen off" feature, it is much harder to see wildlife even if a dash is reasonably dark. Both the Fuga and V37 have display off buttons for night use, they just come back on for a second or 3 if you interact with it, eg skip a song.
×
×
  • Create New...