Jump to content
SAU Community

Recommended Posts

Hi , I have 33 with FMIC exhaust , hks pod, apexi neo AFC and putting in a Electronic boost controller . I was wondering where i can take it for dyno tuning in and around the brisbane area and does anyone have an idea of how much it will cost?

Link to comment
https://www.sau.com.au/forums/topic/185722-dyno-tuning-in-brisbane/
Share on other sites

another tick for godzilla motorsport

have been to a number of tuners, and godzilla have been the stand out of them all and specializes in PFC and other aftermarket ecus. Tunes are performed with laptop software ( none of this handheld shit) to get the ultimate tune right through the rev range.

proof: Mark's 1000hp 8 sec r32 gtr. obviously shows that mark knows his shit and knows what hes doing.

do yourself a favour and do these first.

new spark plugs gapped to 0.8mm

new oil

new oil filter.

if you have stock coils, tape them up good with electrical tape.

the cost always ends up higher than what is quoted because you increase boost and power and you find the spark gives up and you hit missfire issues.

so unless you have split fire coils already, and don't want to spend $500+ on them or get the shits when you book in for a tune and they can't do it cause of spark issues, do the above first.

then they will only charge you for the install/tune.

got the quote today he said $500 with my basic mods, turbo back exhaust, 12psi boost, R34 cooler, pod, which seems pretty good

sparkies already gapped at 0.8, coils removed and refitted with high temp silicone (was getting miss firing at 10 psi, had heaps of coils cracks) , hmmm oil has only done a few thousand clicks should probably change it I guess but that depends on level of motivation.

400KW is #$%^%^ crazy!!!

Edited by SevenAngryPenguins

not sure, but it could just be the same time to tune... my old tuner who was an autronic specialist in sydney did mine within a reasonable time, same time as the power fc i had before. they probs just have a flat rate for tuning, as my old tuner did no matter what ecu... either way you'll be satisfied with the results, and its not that much considering they know hands down what they are doin i spose

hehe yeh 400 is fun, were gonna have it tuned up again just before jambo get around 450 out of it... got the gtr rear end going in now

ben...

Edited by 2BNVS
  • 3 weeks later...

I just moved in to tingalpa; so there are like 3 min away, wonder who much its going to cost to do the following,

Front mount (already got from crashed R33, with piping)

Dump / Front pipe

Hi / Low Boost setting - Dont want to spend on ECU still

Still running Nissan Coil pack though..

do yourself a favour and do these first.

new spark plugs gapped to 0.8mm

new oil

new oil filter.

if you have stock coils, tape them up good with electrical tape.

the cost always ends up higher than what is quoted because you increase boost and power and you find the spark gives up and you hit missfire issues.

so unless you have split fire coils already, and don't want to spend $500+ on them or get the shits when you book in for a tune and they can't do it cause of spark issues, do the above first.

then they will only charge you for the install/tune.

i have stock coils and i didnt need to tape them up lol, when changing plugs the .8 gap is a good idea but u also want to go to a colder temp range. or was that hotter :thumbsup:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...