Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

scandyflick Grand Master

scandyflick

Posted
Posted

if tangles happens to wander through here,

been reading through the 'rise and rise of kevin rudd' thread in the wasteland to kill time, and i like the way you think mate. :)

KISIN Veteran

KISIN

Posted
Posted (edited)

Bosch 023 is the next step up from 040 and can handle roughly 200hp more (~800hp) , and it still fits in-tank ?

That true ?

Is it worth getting this just to be safe (unsure how hard to push the engine at this stage...) ? I saw 1 on ebay for ~$195 delivered. (Says its genuine Bosch). Steer clear of ebay 1s and go get it from a shop ? Anyone using this pump ?

Thanks

Edited by KISIN
Hotwire Veteran

Hotwire

Posted
Posted

Does anyone know who would be best to fix up the trim on my Momo Wheel? it is splitting at the seam, but the condition of the leather is still good, so looking for someone (motor trimmer perhaps?) to essentially glue it back together with the correct adhesives.

Cheers

Matty 31 Grand Master

Matty 31

Posted
Posted

i have what i thought was a 32 gtr wheel, but appears to be a 33 s1 wheel

had it since january....horn didnt work cos of a different setup to the 31

has a slight worn patch at about the 7 o clock position

if it works for ya steve ya can have it

Madaz Grand Master

Madaz

Posted
Posted
http://www.drambuieresearch.com/

Hmm bogans and drambuie do they mix lol :cheers:

ROFL i heard you like it but...

can anyone answer this

ORC TSUINPURETOKURATCHISETTO RB26RB20BNR32BCNR33

will that clutch suit a GTS4 push type ??? :w00t:

this is what i want to get

also does anyone know how much meat is " Disk remaining two are 4.07 mm so still usable. "

chibaken_chibasi-img600x450-1196684723p1000889.jpg

chibaken_chibasi-img600x450-1196684735p1000890.jpg

pokie Mentor

pokie

Posted
Posted

i had 3hrs sleep today and had to go to observation day thingo with

this place i had an interview with on Monday.

it went quick so it was good ;)

oh my brother bought another Celica :rofl: , it's manual so

i'll be learning manual in that when they get it registered

(hopefully next week)

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...