Jump to content
SAU Community

Recommended Posts

This might sound stupid bit can i get a defect for a glovebox that will not open :yes: ? im thinking of making a carbon gauge and boost controler holder that fits inside the glovebox

my glove box has a has a facade that fits inside it, and it holds my water temp gauge, oil temp gauge. and has a spot for my ebc.. there is no room to put anything but a small piece of paper... went thru regency with it in there. it does open, but is essentually useless for anything else.

Changing the glovebox to hold the boosat controller isnt a problem, but having a boost controller is. They will argue that increasing the boost may chjange the emmissions, and hence is illegal (basically any mod that gives you more power could be interperated as changing emissions and hence a breach and defectable)

I know they are illegal and can be seen in the engine bay aswell but for some cops that dont know what they are looking for in the engine bay but know what to look for in the cabin. I thought it would be a good idea to place the controler in the glovebox and maybe have it locked and if i get pulled over ad say iv lost the key lol but can i still get defected for saying the glovebox wont open?

I have tucked mine up infront of the fuse box, you cant see it unless you open the fuse panel.

How often do you use the boost controler? mine is pretty much set and forget (I leave it on low boost, and only open the panel and select high boost on special occasions)

should b fine, similar to what i have, but mine is poxy black plastic :blush: ... im not keen on having boost controller on display, its no longer in there, but thats just me

Talking to a few people I hear regency have installed their emissions tester (though I would prefer external confirmation on this). If this is the case potentially boost controllers and non standard turbos could be considered legal if you could pass the emissions test.

In NSW (where people have public access to such testing centres) tuned cars have gotten through the emissions test, but in SA we don’t have any workshops with the gear to do the proper test.

Whilst it could be done, it would be expensive here in SA.

Edited by 4door_Sleeper

got my PC steering wheel FTMFW !!!!!!!!!

lazy ass post man did not even come to my house to drop off a note that its ready for collection, so it ended up getting sent from my local post office to the general post office in town.. went there to get ti today... (this was delivered from nsw on the 24th dec).

moral of this story... use registered mail with every fkn thing u get from ebay, this seller did not offer it, but even so i should have asked for it.

/rant over

yeah, its in the new gtr discussion forum.

had to happen sooner or later.

::EDIT::

...Looks like the UK

not f**kin likely. last i checked, the symbols on the police bike werent english.

got observation skills?

Edited by scandyflick

how is this for keen !

1029076197_04e6e37c56.jpg

"In Perú from Huánuco to Tingo Maria, where the road from the Pacific coast across the Andes finds its way towards the Amazon lowlands. This is near the top of the last mountain pass. From there, soapbox rider can enjoy a vertical 1000 meters of gravity assisted ride. As these kids help stranded truck drivers along the road, they're called bomberos (firemen). They transport drinks, food and spare parts to broken trucks."

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...