Jump to content
SAU Community

Recommended Posts

any idea how much it changes the track and camber?

i ask cos i recently had an LCA changed and the geometries were suspect when i went for a wheel alignment, and im wondering if i replaced a bent 33 arm that was on the car, with a 32 arm :S

got a fair bit done on the celsior today.

it now has no interior, new alpine speakers have been fitted to the original pioneer boxes in the doors, all the wiring for them has been re routed properly, none of that over through the door cards shit.

stock sub, amp and cd changer have been removed, air purifier has been removed, front doors have been prepsol'd for sound deadening, both new amps have been dummy fitted and yeah... should be done in a week or so. :)

is it possible for a fmic to get F***** over time? well....i suppose painting it chrome, then black dosnt help????

and some of the finns dont really look to flash....

hmmmm, she just doesnt feel the same after yesterday

pfffft^^^ me, never, old owner, ummmmm dirty pig= he never did it either.

maybe you should take it off and clean the inside, you might be suprised how much oil they get in them over time. It stops them cooling properly.

maybe you should take it off and clean the inside, you might be suprised how much oil they get in them over time. It stops them cooling properly.

do i just take it out and leave the piping?

what do i clean it with?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...