Jump to content
SAU Community

Recommended Posts

White rims really go well with the gun metal grey.. if mine weren't staggered fit you could buy them off me :D

Edited by muirsky
relevance of this little brown monster is???? ive seen it everywhere but got nfi what it is

Think of it kinda like a japneese drop bear, but one that actually has an identity. It's a legendry creature/monster that eats everything, so all the "om nom nom nom" things you see are in referance to this little guy (mostly his teeth and eyes are represented).

cr kai youre only gonna get concaved spokes afaik.

id be lookin into ssr's, or maybe xd9's.

but thats just me.

I know they're concaved, but I mean really concaved.

I dunno.. XD9's would be fat ass actually. White,wide,f**k yeah.

is this THE perfect woman?

>>click<<

aside from the fact that she probably aint single, yeah, she'd be close. :P

funnily enough, i noticed her make an appearance in the wasteland just before you posted that, lol.

pokies? now i know where your name comes from. theyre horrid.

LOL that's not why it's my user name :P

i don't play them that often, if i do i only put $2 in and that's it.

the 1st time i played them i won $70 from putting $1 in :D

so, just for the f**k of it, im gonna post some pics of the new evo, i think theyre rad, reading though the recent mallala thread, seems not many people share that opinion, what does everyone think?

mitsubishi-lancer-evolution-x.jpg

2-2297966213_a77a1dc729.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...