Jump to content
SAU Community

Recommended Posts

The weather is looking like shit, and I gotta ride home in it. :teehee:

Hot shower for me when I get home. At least the Brutale gets a wash :D

Oh, and I'm finishing off the rebuild to my pitbike tonight. A few mods, slicks and I'm taking it to the Pooraka track this weekend. Lap record anyone? :(

Edited by RubyRS4

^^ Ruby is the track you speak of at the old 'Megakarts' place (just near Paddys Market)???

I used to go there all the time as a lad, ah memories :(

anyone got cains (? dude with the tt zed) number? i want his advans.

Got it yet? I can PM ya if you want (although I haven't spoken to Conrad in some time now, dunno if he's got a new number recently or whatever)

151 is the strongest legal alcohol u can puchase, being ~76% and a full bottle being 44 standard drinks lol. i dont drink but i see the affects of it all the time.

It must be 151 proof (divide by 2 to get the alcohol % in this case 75.5%)

The stuff we make comes out at about 80% (160 proof) and is almost pure ethanol. The best bit is you dont get as bad a hangover in the morning as there are fewer imputities than traditionally distilled spirits.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...