Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

J - Rad Veteran

J - Rad

Posted
Posted

Good luck to all the boys going on the Toy Run today. Stay safe.

Yeah that Twilight movie was pretty shit to be honest. To much loving, not enough slaughter. Also its obviously going to be a series of movies be the end of it. Great :)

J - Rad Veteran

J - Rad

Posted
Posted

Lol. Like half way through the movie I needed to piss so bad, but I didn't wanna miss anything because Jen would of explained it all to me later. I love the " we can only play Baseball during Thunderstorms" bit.

scandyflick Grand Master

scandyflick

Posted
Posted

i think may have been one of the many scenes where my attention waned somewhat.

the only thing that movie has going for it is the reasonably cool soundtrack.

now, 'in bruges', thats a cool movie.

Tangles Grand Master

Tangles

Posted
Posted

i miss my stagea

want her back now

bets on dyno queen rwkw figure - I say 230 at 1.1bar this tune (poncams, head)

and perhaps 245 next tune (HKS AIC-4 additional injector controller, & Sard intake manifold setup with 2x700cc Sard injectors~ mounts near bov)

:sad:

DSTROY Grand Master

DSTROY

Posted
Posted (edited)

I took my car to Pedders in Morphett Vale on Friday afternoon, good bunch of guys there. They spend an hour with me looking over my suspension looking for any problems and also got a very good quote on an adjustable front sway bar, when i left i asked them how much i owe'd them and they said not to worry about it. So if ya live down south i'd def recommend taking your car to them if you need any suspension gear :)

Edited by DSTROY
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...