Jump to content
SAU Community

Recommended Posts

Nissan Silvia :D

:mad:

Hell no! Okay ... has 5 x 114 wheels ... 19" to be exact!

Anyone wanna phone a friend? Buy a vowel?

Extra hint: blue mesh will not be going on it ... wouldn't suit it.

Edited by RubyRS4
White Toyota Prius with 5 bolt Hub conversion and work emotion cr kai 19x9

-D

*groan

You guys give an asprin a headache man!!!

Last hint: members can't complain about an SAU:SA Committee member owning one!

huh, big enough hint now, huh? :mad:

Close :mad:

Not a 32, not awd (unfortunately)

Ohh a 33 gts-t.

"Rubys on a boat motherf**ker would u look at he,

he's on a boat in the middle of the deep blue sea...

Hes on a boat

Hes on a boat

Errybody take a look

at Rubys motherf**kin boat"

-D

Specs? Pics? :D

White R33 GTS-T 4 door

RB25DET (naturally)

Auto (but not for long)

127,xxx kms

Has work done to brakes. Purrs, doesn't miss a beat. Recently fully serviced.

Straight as. Interior in excellent condition.

I went over this car in and out, but it was night time. I'll take a better look during the day tomorrow.

Tracy and I are already looking at bodykits :mad:

This'll be our daily.

Edited by RubyRS4
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...