Jump to content
SAU Community

Recommended Posts

I was looking over my battery the other day it has an earth kit but there isnt a -ve cable connected to the battery is this bad even though i have a n earth pack.

Also the car has had a miss for the last couple of weeks but on friday the car keeps surging while driving and just dies at the lights when i pull up. Also has little mental fits and wont go over 2500rpm.

Ive changed the following.

Fuel filter

spark plugs

cleaned the afm

and the idle solenoid thingy

had a look at coils took one off at a time and noticed 5 wasnt firing so I bought a coil from nispro still running shit.

reset the ecu

Edited by devos2be
Link to comment
https://www.sau.com.au/forums/topic/190258-ok-todays-mission/
Share on other sites

OK no the earth pack is sweet But heres a real problem today i thought i would try and solve my miss fire problem. I pulled everything off got all the coils out had a good inspection at all of them. Noticed also there was an oily no.6 spark plug ,I was reading some of the syptoms and it said ,bad internals or wrong fuel/oil ratios can anyone help me with this new ongoing problems im having with my car.I did just recently change the oil . I'll try another oil change 2mrw and buy a new spark plug.

Ok will do that first thing monday .

Today i was going to check the ecu codes! Apart from the coil problem im having .The car in the past 2 days has been dying completly when im just about to stop at the lights or when im just cruising it will just start to surge on and off throwing me head around like a rag doll. Then it will either come good or just die .All the dash lights come up so i dont think its the battery ,changed the fuel filter spark plugs about 1 mnth ago(hoping to solve the problem no luck) .Yesterday checked all the coils took out all the spark plugs No.6spark plug was black and smelt like fuel/oil.Cleaned AFM it was covered in heaps of black shit. cleaned pretty much all of it off.Cleaned the idle solenoid thingy(picture)Put it all back together started her up pulled the plugs one at a time and coil 5 wasnt firing wich means its definately a coil if 6 had the black spark plug. Ive been reading a fair few posts and I think my problem with the car cutting out is a different problem. Because ive had the shit coil for about 2mnths now this has just popped up.

Either:

1. Fuel pump

2.crank sensor shat itself

3. Please add

will add a new pic in 20mins charging camera

Compression test on monday

post-28526-1193440159_thumb.jpg

Edited by devos2be

yeah the engine dying problem just came out of the blue but the missing problem was like 2mnths ago.

I did put it in at the mechanics about 1mnth ago to try and fix it ,They changed and checked spark plugs cleaned the afm changed the fuel filter and checked the ecu for anything and still nothing.but that was when the engine missing problem wasnt as bad and not a constant miss!!!!!!??!!

COuld the missfiring have gotton worse and maybe its forcing the cars ecu into limp mode?

Im taking it to another mechanic 2mrw for a diagnostic check to these guys just of christine ave (gold coast) i think they're called STOICHE correct me if im wrong ,but they have some bullshit performance cars there and can hopefully shed some light on my so shitty day.

I also bought a coil and tryed no change but i havent changed that oily black spark plug yet either ,all the other plugs were pretty white should i just throw them all and start over???

(car runs realy good after i reset the ecu still misses but it doesnt just die , until i turn it off.

Cars mods: 1 drift airfilter

Exaust only from the cat back 3'', and a earth kit if you can call that a mod but thats about it.

What should the standard oil pressure read when cruising at 60 (mine is just below 4)???????

Anyway fingers crossed for 2mrw!!!!!!!

post-28526-1193648270_thumb.jpg

Ok just walked back from mechanics after work not my favourite thing to do(walk) .

They havent fully sussed out the problem yet but they are pretty sure its a sensor.

I dont know what the f**k to do with getting realy frustrated with it?

Just wondering if anyone knows good mechanics on the gold coast with payment plans if any?????????????????????????????????????????????????

Because this is sounding expensive and it has been a real hard year on the wallet.

ok so i had to take the car back from stoiche performance but i will take it back to them 2mrw for round 2.

But for now can anyone explain what these bits and peices a i have pictured please?

this was a connection beside the afm dont know what it is. hers a better pic of it location

post-28526-1193894284_thumb.jpg

post-28526-1193894510_thumb.jpg

post-28526-1193894630_thumb.jpg

Edited by devos2be

some more pics of the disabled beast (stock pussy cat really)

The AFM after i cleaned the shit out of it the whole thing was pretty much coated in black shit.

How much do these things cost anyways..

post-28526-1193894832_thumb.jpg

post-28526-1193894866_thumb.jpg

post-28526-1193894906_thumb.jpg

post-28526-1193895395_thumb.jpg

Edited by devos2be
first picture is an electrical boost gauge unit.

i assume the plugs in the 2nd/3nd picture were together? cause they should be.

yeah what are they they're bloody filthy with gunky yellow shit all thru it or should it be like that???

Im thinking it could be your CAS. If it is a sensor you'll save yourself a crapload of money doing the ECU diagnostic which will tell you which one broken. Sensors are usually pretty cheap and easy to replace. O2 Sensors seem to be going left right and centre at the moment.

$300 for new Z32 afm

under $100 for 2nd hand stockie

either clean that spark plug in some petrol, or carefully with a wire brush etc or pay $4 for a new one. if it gets fouled again, there may b esomething wrong with that cylinder.

if there was oil gettting into the intake, it would be on all the plugs. either it is, and the other cylinders are happily burning it away, but no.6 is a weak spark etc. or the cylinder with the bad plug has bad rings or another problem. If your mechanic wants to rebuild it it may be cheaper to just buy a second hand engine rb20s are cheap as chips.

as a quick check, swap the coil and plug to other cylinders and see if the problem moves too. how does it run, obviously stalling but does it rev smoothly or sound like a tractor

Thanks for your feed back guys, as for the spark plug it only had oil on one, which i did attempt to clean.replacing today.Finally got the day off ill have a fiddle with it.

Was just wondering what CAS is????

But I really need to sort this car dieing on me all the time ,like the car has been missing for a mnth or so but this complete shut down shit just sucks?

Its like the car gets thrown into limp mode and wont push over 2500rpm.

post-28526-1194119943_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...