Jump to content
SAU Community

Recommended Posts

i have a built 26 with a trust oil pump and recently installed a just jap oil cooler and connected my defi gauge senders up.

oil pressure is good driving normally, but when i boot it, oil pressure stays above 6 bar until it reaches about 6500rpm and falls to about 3.5 bar by 8000rpm.

rev limiter is set at 9000rpm so would probably drop below 3 bar by then :thanks:

i also have fresh oil in there, castrol edge 10w-60

thanks,

luke

could be a myriad of things, the cheap coolers are not real good for flow but we ran twin JJR coolers on the car in my sig with no issues. remove the inlets and check to see if the inlet is half covered... some of them are and these coolers are useless. If it isnt this i would suspect incorrect clearances by whoever built it..

thanks for your reply,

what do u mean by check if the inlet is half covered?

another question, is it important which way the oil flows? ie. engine > filter block > cooler > back to engine

Edited by luke20t
thats called oil surge mate.

next time it does it. just stop acellerating. and it should leval out. basicly keep filling oil till it stops surging.

even though the sump is baffled and the oil level is almost on full on the dipstick?

depends what sump you have, stock gtr sump wont but if your running an rb rwd sump (assuming the car isnt a gtr) then there is every chance no matter how much oil you stick in there it is going to surge.. mine was the same

added more oil..

booted it a couple times and the oil pressure seems to be holding above 6 bar.

i cant believe how much oil i have put in now! close to 6.5 litres!

just hope this wasnt happening b4 i put the cooler in, because i never had it so full.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...